Sound Tube IPD-XT850 Configuration guide

Install Instructions For:
1.435.647.9555 | 800.647.TUBE | www.soundtube.com
IPD-XT850
#8 Stainless-steel
square-drive screw (x6)
Speaker enclosure
Liquid-tight RJ45 coupling
Speaker base
Pre-installed Cat5 Cable
RJ45 connector
.75" 1/4-20 Stainless-steel bolt
In-ground/security bracket
Box contents
1 In-ground speaker
1 in-ground/security bracket (2 pieces)
1 Liquid-tight RJ45 coupling compression tting
1 Square drive bit
6 #8 stainless-steel square-drive screws
2 .75" 1/4-20 Stainless-steel bolts
IPD-XT850

Install Instructions For:
1.435.647.9555 | 800.647.TUBE | www.soundtube.com
SoundTube speakers must b e installed b y a p r ofessional audio
installer/contractor. For safety and for optimum audio performance,
installer must follow all directions issued by SoundTube Entertainment.
Warning
IPD-XT850
1. Attach inground/security
brackets to speaker base
using stainless-steel bolts.
4. Plug Cat5 cables into
coupling. No wire nuts
needed. Tighten tting to
seal.
2. Field route Cat5 cable
from the switch to each
IPD-XT850, direct burial
cable or use of conduit is
required. The cable may
need to be terminated after
routing the cable through
the compression tting of
the liquid-tight RJ45 coupling.
Tighten tting to seal.
3. Dig a hole that is 15”
wide and 5” deep. Place
speaker base ino the hole in
the ground with the top rim
of the base at ground level.
Back-ll dirt into hole. For
added security, cement
security brackets into ground.
5. Set speaker enclosure on
speaker base. Use tamper-
resistant stainless-steel
screws to attach
speaker to base (driver
tip and screws provided).
6. Done!
IPD-XT850
Software and firmare updates for SoundTube Dante-enabled speakers can be found on our website. Go to
www.mseaudio.com/downloads and navigate to SoundTube and download the necessary software for your IPD-XT850
speaker.
Additional Information