INITIAL INSTALLATION
BUTTON IDENTIFICATION
1. VOLUME/OFF
2.
3. AL ON/OFF
4. AL SET
5. TIME
6. AM/FM
7. HOUR
8. MINUTE
9. LCD DISPLAY
10. TUNING
11. MIRROR
12. HANDLE
13. ADJUSTABLE STAND
14. BATTERY DOOR
15. HANGER SLOT
GB-1
Loosen the screw with a
screwdriver and remove
install batteries to its replace the cover
correct polarity to fasten the screw
NORMAL TIME SETTING
1. PRESS THE KEY COMBINATION OF [LIGHT/TIME] [HOUR]
OR [MINUTE] TO ENTER THE TIME SETTING.
2. ONE DIGIT WILL BE INCREMENTED . KEEP PRESSING UNTIL THE
CORRECT TIME APPEARS.
GB-2
ALARM SETTING
1. SET VOLUME/OFF KNOB AT OFF POSITION. PRESS AL ON/OFF
BUTTON TO ACTIVATE THE ALARM FUNCTION
2. PRESS AL SET AND HOUR BUTTON SIMULTANEOUSLY AND THE AL
INDICATOR WILL TURN ON AND THE [:] WILL STOP BLINKING.
PRESS THE TWO BUTTONS UNTIL THE DESIRED HOUR APPEARS,
THEN PRESS AL SET AND MINUTE BUTTON TOGETHER TO SET
THE DESIRED MINUTE.
3. IF NO ALARM ICON “ ”APPEARS ON LCD, PLEASE PRESS AL
ON/OFF TO TURN ON ALARM ON AND THE ALARM ICON WILL
SHOW ON UPPER RIGHT CORNER.
4. IT WILL ACTIVATE THE ALARM AT THE PRESET TIME. PRESS AL
OFF TO STOP THE ALARM OR IT WILL STOP AUTOMATICALLY IN
THREE MINUTES.
5. TO CANCEL THE ALARM FUNCTION JUST PRESS AL ON/OFF
BUTTON.
NOTE: TO VIEW THE ALARM TIME, PRESS AL SET BUTTON.
RADIO OPERATION
1.TURN THE VOLUME TO YOUR DESIRED LISTENING LEVEL AND
SET THE BAND SELECTOR TO YOUR FAVOURITE BAND(AM/FM).
THEN ROTATE TUNING KNOB TO CHOOSE RADIO STATION THAT
YOU WANT.
2.ON RADIO MODE PRESS THE MODE BUTTON AND THE CURRENT
TIME WILL SHOW ON THE DISPLAY.
NOTE: BOTH FM AND AM ANTENNA ARE BUILT-IN IN THE UNIT.
GB-3
BACKLIGHT
PRESS LIGHT/TIME BUTTON TO TURN ON THE BACKLIGHT TO SEE
THE DISPLAY FOR FEW SECONDS.
MOUNTING
USING THE ADJUSTABLE STAND:
THE UNIT CAN STAND ON THE TABLE AT TWO DIFFERENT ANGLES
BY PULLING OUT THE ADJUSTABLE STAND. IT WILL STOP AT ONE
OF THE TWO CLICKS IN THE CABINET.
USING THE HANDLE :
TAKE OUT THE HANDLE AND HOOK IT SECURELY ON THE WALL.
USING THE HANGER HOLE:
HANG THE UNIT ON THE WALL USING THE HANGER SLOT AT THE
BACK OF THE UNIT .
SPLASH PROOF:
THE UNIT IS DESIGNED FOR SPLASH PROOF (IPX4) IN THE SHOWER.
BUT DO NOT IMMERSE IT IN WATER.
VENTILATION WARNING:
THE NORMAL VENTILATION OF THE PRODUCT SHALL NOT BE
IMPEDED FOR INTENDED USE.
GB-4
MODE
LIGHT /
