Soundstream SDR-656T User manual

SDR-656/SDR-656T
6.5” Monitor
MP3/MP4 Player
AM/FM Radio
Built-in TV tuner (only for SDR-656T model)
Owner’s Manual
Take the time to read through this owner’s manual.
Familiarity with installation and operation procedures will help you obtain the best
Performance from your new device.

2
Important Safeguards
zUsing the device at temperature below -10℃may cause the breakage of the device.
BEFORE USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE
RECOMMENDED TEMPERATURE!
zRead carefully through this manual to familiarize you with this high-quality sound system.
zDisconnect the vehicle's negative battery terminal while mounting and connecting the unit.
zWhen replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse
with a higher amperage rating may cause serious damage to the unit.
zMake sure that pins or other foreign objects do not get inside the unit; they may cause
malfunctions, or create safety hazards such as electrical shock or laser beam exposure.
zIf you have parked the car for a long time in hot or cold weather, wait until the temperature in
the car becomes normal before operating the unit.
zDO NOT open covers and do not repair yourself. Consult the dealer or an experienced
technician for help.
zMake sure you disconnect the power supply and aerial if you will not use the system for a long
period or during a thunderstorm.
zMake sure you disconnect the power supply if the system appears to be working incorrectly,
(For example: making unusual sounds, smelling strange, emitting smokes from inside or
liquid having gotten inside it）Have a qualified technician check the system.
zThe unit is designed for negative terminal of the battery, which is connected to the vehicle
metal. Please confirm it before installation.
zDo not allow the speaker wires to be shorted together when the unit is switched on. Otherwise
it may overload or burn out the power amplifier.
zDo not install the detachable panel before connecting the wire.
zDon't remove the detachable panel when encoding.

3
Contents
Important Safeguards...................................................................................................................2
Contents.......................................................................................................................................3
Accessories..................................................................................................................................4
Installation/Un-installation ............................................................................................................5
Wiring Connections......................................................................................................................6
Panel Control ...............................................................................................................................8
Remote control.............................................................................................................................9
Remove Battery ...........................................................................................................................9
Main Menu .................................................................................................................................10
◆Radio Player.....................................................................................................................10
◆USB/SD/MMC Interface ................................................................................................... 11
◆TV Mode(only for SDR-656T)...........................................................................................12
◆AV-IN Mode ......................................................................................................................13
◆Setting Control .................................................................................................................13
Other Functions ......................................................................................................................... 15
Troubleshooting guide................................................................................................................16
Specification...............................................................................................................................17

4
Accessories
Package contains the following accessories for installation and operation of the unit.
(1) Washer, Spring
Washer, M5 Nut 1 each
(2) Mounting Strap 1
(3) Bolt 5*20 1
(4) Screw 5*6 4
(5) Mounting Collar 1
(6) Release Key 2
(7) Screw 5*20 1
(8) Rubber Cushion 1
RemoteControl Warrantycard
User Manual
Noted:
Product image may vary from the actual delivery
ISO cable
Trim ring
RCA Cable

5
Installation/Un-installation
Note
Before starting installation of the unit, make sure the wiring is connected properly.
Use only the parts provided with the unit to ensure proper installation.
The use of unauthorized parts may cause malfunction.
Install the unit where it does not get in the driver’s way and will not injure the passenger in case
there is a sudden stop, like an emergency stop.
INSTALLATION （Figure 1）
Insert Half Sleeve into dash-board hole and bend mount tabs outwards to fix it
If necessary, place the mount strap at the rear of the unit and fix it with provided washer as
figure 2.
Push the unit into the Half Sleeve until you hear a click sound
Place Trim Ring over the unit and installation is completed as figure 3. (Some vehicle may not
need Trim Ring)
UN-INSTALLATION
Insert the supplied extraction keys into the unit and pull the unit out with keeping the extraction
keys. (as Figure. 4)

6
Wiring Connections
NOTE: Never connect cable to the system while it is connected to the battery power. Whenever
the unit is disconnected from the battery, the preset memory will be erased and the unit will go
back to its factory defaults.
Note: To watch video the parking wire should be connected to break signal. 2 cables is
connected to a Hands-Free device (not included).
Parking wire
Note: The parking wire is connected with brake signal; for safety, the programs can be seen on
the monitor after braking the car.
Connecting the reversing line to taillight on the car
After connecting, when you start up the reverse gear, the unit will receive the picture from car
rear view camera.

7
Note:
- Only use groundless loudspeakers.
- Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging your
loudspeakers at higher volumes.
- Use 4~8 Ω(Ohm impedance) loudspeakers only; using higher or lesser impedance may
damage the unit.
- Do not use 3-cable loudspeakers and do not connect the loudspeakers minus to the car
body (GND). The unit is using a BTL circuit and each loudspeaker must be connected with
insulated cables according the diagram.
- Loudspeaker cables and/or optional external power amplifiers must always be about
30cm away from the antenna and/or antenna extension parts.
Connect the speakers according the following diagram, incorrect connections will damage the
unit or your loudspeakers
Correct connection
Left front - Right front | Left rear - Right rear
Incorrect connections

8
Panel Control
1. POWER/MUTE Button
Press it to turn on the unit. When turned on, press it to mute the volume output, press and hold
for 2 seconds to turn the unit off when the unit is on.
(* Press any button on panel to turn on the unit)
2. VOL Knob
Adjust the volume level by turning the knob clockwise to increase or counterclockwise to
decrease.
3. MODE Button
Press it to select the mode: Radio, USB (if there is a USB device in the unit), CARD (if there is a
SD/MMC card in the unit), TV (For SDR-656T) and AV IN.
4. IR Sensor
IR Remote control signal receiving window. Max distance is 6-8 meters, 45 angels.
5. RESET Button
Press it with a thin, sharp object. The device will then be reset to factory default settings.
6. TFT SCREEN
7. SD CARD Slot
SD/MMC card slot, for Multimedia playback files only. Insert a SD/MMC CARD into this slot and
the unit will automatically start reading and playback the card. * Supported Music File Format:
MP3, WMA Files.
8. USB Jack
USB slot, for Multimedia playback files only. Insert a USB into this slot and the unit will
automatically start reading and playback the files. * Supported Music File Format: MP3, WMA
Files
9. AV IN Jack
Put the AV plug into the AV-IN in jack which was marked on front panel.

9
Remote control
Remove Battery
Note:
The distance may vary according to the brightness of ambient light.
If the remote is not used for an extended period of time, remove the battery to prevent
possible damage from battery leakage and
corrosion.
Do not place any objects between the remote
control unit and the sensor on the unit.
Do not drop the remote control onto the floor; it
will damage it beyond repair.
Do not use the remote control unit, while simultaneously operating the remote control unit of
any other equipment; they may interfere resulting in improper operation.
The battery normally last for about one year although depending how often the remote
control is used. If the remote control unit isn’t working even when it is operated near the unit,
replace the battery with a new battery of the same make and use only a lithium cell battery
type: CR2025 (3V).
Dispose empty batteries in accordance with your local governmental regulations.
Do not short-circuit, disassemble, heat or dispose of fire or flames the battery.
Keep the battery out of reach of children, should the battery be swallowed, immediately
consult a doctor.
1: MENU
2: POWER
3: UP
4: BAND/M.SEL/RDM
5: ENTER
6: LEFT/SEEK-/FAST BACKWARD
7: DOWN
8:REPEAT/INT
9: AS/PS
10: MODE
11:DIGIT NUMBER
12:PLAY/PAUSE
13:MUTE
14: AUDIO
15: SUBTITLE
16:RIGHT/SEEK+/FAST FORWARD
17:VOLUME PLUS
18:SET
19: VOLUME MINUS
20: EQ/LOUD
21: SEL
22: SCALE/ROTATE
23: GO TO

10
Main Menu
The best way to discover the program is to explore each screen in detail, and to find out how to
move from one to another. Read this chapter for a guided tour.
Unit starts by displaying the Main menu.
This is the root of the screen hierarchy, and you can simply access all features by tapping on the
touch screen buttons.
Tap the icons to enter a desired mode.
Radio Player◆
To start Radio, tap RADIO button on main menu screen, or press the MODE button on the
front panel or RC repeatedly.
Touch it to adjust the volume
Touch this button can scan the stations from 1-6, Long Touch it to save the stations with
good reception automatically and scan each station for about 5 seconds
Touch this button to search stations backward automatically.
Touch this button to open manual select station backward.
Touch this button to open manual select station forward.
Touch this button to search stations forward automatically.