southpaw enterprises Static Eye Bolt Wrap 7011 User manual

southpaw enterprises, inc.®
Instruction Sheet
Static Eye Bolt Wrap 7011
Store these instructions with the enclosed maintenance checklist in
a safe place. You may also access them on our website.
WARNING! Shackles will wear with use and must be inspected on a regular basis. Dis-
continue use of shackle and replace or have repaired immediately when wear begins to
show. Do not let wear exceed 30% of the shackle.
IMPORTANT: Please check equipment immediately for any damage that may have resulted during shipping.
If any damage has occurred, please contact Southpaw Enterprises, Inc. immediately.
MATERIALS LIST TOOLS NEEDED
1 - Static Eye Bolt Wrap Two 3/4” wrenches
1 - Instruction Sheet
1 - Maintenance Checklist
INSTALLING THE EYE BOLT WRAP
• Place the bracket strap (the piece without the shackle) on top of the cross beam at a safe distance from the end
post. (Put the side with the shock pad against the cross beam).
• Put one flat washer on each of the hex head bolts, then put them through the holes in the hanger strap (the piece
with the shackle), going through from the shackle side.
• Put the bolts up through the holes in the bracket strap. Place a flat washer, a lock washer, and a non-locking nut
on each of the bolts. Tighten finger tight evenly.
• Tighten the bolts by holding the head of the bolt with one 3/4” wrench while using the other wrench to tighten the
nut. Alternate from one nut to the other, tightening them both evenly.
• When both bolts are tightened securely, put a self-locking nut on each bolt and tighten it down firmly against the
non-locking nut.
HEIGHT ADJUSTER OR SAFETY ROTATIONAL DEVICE NEEDED
A Southpaw Height Adjuster (# 5000) may be needed to adjust your equipment to the correct height for your client.
With all Southpaw suspended equipment, a Safety Rotational Device must be used to prevent damage to your
equipment.
MATTING PRECAUTIONS: Always use appropriate matting.
MAINTENANCE CHECKLIST
All of the following wear points should be checked on a daily, weekly or monthly basis and recorded on the checklist
enclosed.
• Try to turn the eye bolt on a DAILY basis. If it turns at all, remove and have repaired or replace immediately.
• Check to make sure that all nuts and bolts are tight on a weekly basis. If loose, discontinue use immediately until
tightened.
• WARNING! Check for eye bolt wear. If wear exceeds 30% of the diameter of the eye bolt, discontinue use
immediately and call Southpaw for repair or replacement.
• Use a Southpaw Safety Rotational Device (item #2000) to prevent abnormal wear and damage to equipment.
When replacing Safety Snaps or Rotational Devices due to normal wear, use only Southpaw replacement parts.

Safety Precautions - The safety of your clients is dependent on the appropriate choice of activity to match, yet challenge their
physical abilities. Use appropriate spotting / safety techniques. In addition, the layout of your activity area, proper installation and
maintenance of your equipment is critical. Southpaw equipment is not intended for recreational or outdoor use. Under no condition
should this equipment be used without proper supervision.
This sheet is for example only. It is not meant to, in any way, replace local, county, state, or Federal standards. Be aware - it is
your responsibility to find all pertinent safety information that pertains to your facility.
Southpaw
Enterprises Inc.®
If you have any questions or comments, please call or write
Southpaw Enterprises, Inc.
P.O. Box 1047, Dayton, Ohio 45401 -1047
Toll Free - [phone]
Come see us on the World Wide Web at http://southpawenterprises.com
FORM CODE: XI-7001 REV 04 / 98 © 1998 Southpaw Enterprises, Inc.
 Check eye bolt for wear and movement. Discontinue use of eyebolt and replace immediately when
wear begins to show. Do not let wear exceed 30% of eye bolt. Use a Southpaw Safety Rotational
Device to prevent abnormal wear.
 Floor mats of proper thickness should be positioned properly under and around all suspended
equipment.
CAUTION
CLEANING INSTRUCTIONS
Check with your infectious disease department before using these procedures.
• Wipe with a dry cloth.
Take time to familiarize yourself with the use and maintenance of this equipment before using. Please file
this Instruction Sheet in an accessible location: the Instruction Sheet must be read and familiar to anyone
who is using Southpaw Enterprises Equipment.

southpaw enterprises, inc.®
Instruction Sheet
Swivel Wrap 7012
Store these instructions with the enclosed maintenance checklist
in a safe place. You may also access them on our website.
Take time to familiarize yourself with the use and maintenance of this equipment before using. Please file
this Instruction Sheet in an accessible location: the Instruction Sheet must be read and familiar to anyone
who is using Southpaw Enterprises Equipment.
IMPORTANT: Please check equipment immediately for any damage that may have resulted during shipping.
If any damage has occurred, please contact Southpaw Enterprises, Inc. immediately.
MATERIALS LIST TOOLS NEEDED
1 - Swivel Wrap Two 3/4” wrenches
1 - Instruction Sheet
1 - Maintenance Checklist
INSTALLING THE EYE BOLT WRAP
• Place the bracket strap (the piece without the shackle) on top of the cross beam at a safe distance from the end
post. (Put the side with the shock pad against the cross beam).
• Put one flat washer on each of the hex head bolts, then put them through the holes in the hanger strap (the piece
with the eye bolt), going through from the shackle side.
• Put the bolts up through the holes in the bracket strap. Place a flat washer, a lock washer, and a non-locking nut
on each of the bolts. Tighten finger tight evenly.
• Tighten the bolts by holding the head of the bolt with one 3/4” wrench while using the other wrench to tighten the
Nylon locking nut. Alternate from one nut to the other, tightening them both evenly.
• When both bolts are tightened securely, put a self-locking nut on each bolt and tighten it down firmly against the
Nylon locking nut.
HEIGHT ADJUSTER OR SAFETY ROTATIONAL DEVICE NEEDED
A Southpaw Height Adjuster (# 5000) may be needed to adjust your equipment to the correct height for your client.
With all Southpaw suspended equipment, a Safety Rotational Device must be used to prevent damage to your
equipment.
MATTING PRECAUTIONS: Always use appropriate matting.
MAINTENANCE CHECKLIST
All of the following wear points should be checked on a monthly basis and recorded on the checklist enclosed.
• Check to make sure that all nuts and bolts are tight. If loose, discontinue use immediately until tightened.
• Check to make sure that the eye bolt turns smoothly. If the eye bolt makes a noise while spinning, lubricate with
a grease gun at the grease fitting above the eye bolt. Add grease slowly until grease starts to appear where the
eye bolt turns in the bracket.

Safety Precautions - The safety of your clients is dependent on the appropriate choice of activity to match, yet challenge their
physical abilities. Use appropriate spotting / safety techniques. In addition, the layout of your activity area, proper installation and
maintenance of your equipment is critical. Southpaw equipment is not intended for recreational or outdoor use. Under no condition
should this equipment be used without proper supervision.
This sheet is for example only. It is not meant to, in any way, replace local, county, state, or Federal standards. Be aware - it is
your responsibility to find all pertinent safety information that pertains to your facility.
Southpaw
Enterprises Inc.®
If you have any questions or comments, please call or write
Southpaw Enterprises, Inc.
P.O. Box 1047, Dayton, Ohio 45401 -1047
Toll Free - [phone]
Come see us on the World Wide Web at http://southpawenterprises.com
FORM CODE: XI-7002 REV 04 / 98 © 1998 Southpaw Enterprises, Inc.
 Check ceiling eye bolt for wear and movement. Do not let wear exceed 30% of eye bolt. If the eye
bolt moves excessively, discontinue use until all hardware is checked and tightened. Use a Southpaw
Safety Rotational Device to prevent abnormal wear.
 Floor mats of proper thickness should be positioned properly under and around all suspended
equipment.
CAUTION
• WARNING! Check for eye bolt wear. If wear exists, it should not exceed 30% of the diameter of the shackle. If it
does, discontinue use immediately and call Southpaw for repair or replacement.
When replacing Safety Snaps or Rotational Devices due to normal wear, use only Southpaw replacement parts.
CLEANING INSTRUCTIONS
Check with your infectious disease department before using these procedures.
• Wipe with a dry cloth.

southpaw enterprises, inc.®
Instruction Sheet
Replacement Eyebolt Kit 7015
Store these instructions along with the enclosed maintenance checklist
in a safe place. You may also access them on our website.
MATERIALS LIST:
1 - Eyebolt 1/2-13 x 6”
1 - 1/2” Flat Washer
1 - 1/2-13 Lock Nut
TO REMOVE WORN EYEBOLT:
Insert a large screwdriver through the “eye” of the eyebolt to keep it from turning while you loosen the nut using a 3/4”
wrench. Remove the eyebolt and discard the used parts. Do not reuse the old lock nut or washer.
TO INSTALL NEW EYEBOLT:
Insert the new eyebolt into the beam from the bottom to the top. Put the 1/2” washer on the bolt. Start the 1/2” lock nut
on the bolt. Insert the screwdriver through the “eye” of the eyebolt to keep it from turning while you tighten the nut.
When the nut is almost tight, turn the screwdriver to properly align the eyebolt and tighten the nut securely.
Take time to familiarize yourself with the use and maintenance of this equipment before using. Please file
this Instruction Sheet in an accessible location. The Instruction Sheet must be read and familiar to anyone
who is using Southpaw Enterprises Equipment.
IMPORTANT: Please check equipment immediately for any damage
that may have resulted during shipping. If any damage has occurred,
please contact Southpaw Enterprises, Inc. immediately.
Warning: Failure to properly install a forged
steel eyebolt (1/2” or 5/8”) may result in serious
injury or death. If you have any questions
about the installation of the forged steel
eyebolt, please contact Southpaw Enterprises
FORM CODE: XI-7015 © 2007 Southpaw Enterprises, Inc.
If you have any questions or comments, please call or write
Southpaw Enterprises, Inc.
P.O. Box 1047, Dayton, Ohio 45401 -1047
Toll Free - [phone]
Come see us on the World Wide Web at http://southpawenterprises.com
Southpaw
Enterprises Inc.®
Safety Precautions - The safety of your clients is dependent on the appropriate choice of activity to match, yet challenge their
physical abilities. Use appropriate spotting / safety techniques. In addition, the layout of your activity area, proper installation and
maintenance of your equipment is critical. Southpaw equipment is not intended for recreational or outdoor use. Under no condition
should this equipment be used without proper supervision.
This sheet is for example only. It is not meant to, in any way, replace local, county, state, or Federal standards. Be aware - it is
your responsibility to find all pertinent safety information that pertains to your facility.
♦ Check ceiling eye bolt for wear and movement. Use a Southpaw Safety Rotational Device to prevent
abnormal wear.
♦ Client should always wear a safety helmet with all suspended equipment.
♦ Floor mats of proper thickness should be positioned properly under and around all suspended
equipment.
CAUTION