SPÜLBOY NU User manual

Spülboy® glass washing concepts –Schäfer Produkte GmbH
www.spuelboy.de
Welcome to the NU® world!
”Save the taste! “
This is our international aim, especially when it comes to beer: perfect
pleasure “from the keg to the glass”. Spülboy is an indispensable part
of this quality chain and is worldwide appreciated by breweries and
restaurateurs. Spülboy is setting standards for all bar areas because
only hygienic, crystal clear glasses guarantee the unique taste.
Your beer deserves it. And your customers will love it.
5 steps how to install & how to use
Hereinafter we would like to give you some short instructions how to
install and operate your Spülboy NU properly.

Spülboy® glass washing concepts –Schäfer Produkte GmbH
www.spuelboy.de
1Spülboy NU contents
1 glass washing device
1 middle brush with head
1 brush strip
1 2- step rinse valve
1 overflow pipe
1 connection hose incl. easy clix fast connection & 3/8” threat

Spülboy® glass washing concepts –Schäfer Produkte GmbH
www.spuelboy.de
2 preparations for proper usage
Please open the plastic bag and control the completeness of your
Spülboy NU → see drawing at step 1
Take out the connection hose and put it one the spout. Doing this
please note that the securing slide of the easy clix connector is in
position off. Check the correct position of the small rubber seal device
side as well. If the easy clix sits on the spout properly please switch the
secure slide in position on. A “clix” signals the lock.
3 installation to the water supply
Place your NU in a sink or an appropriate tank. Now fix the end of the
hose with the 3/8” threat to your faucet. Please pay attention of the
correct position of the rubber seal hose side.

Spülboy® glass washing concepts –Schäfer Produkte GmbH
www.spuelboy.de
4 first commissioning and daily usage
Before first use please flush the Spülboy by operating the rise part for
minimum 5 sec. Then fill the pre washing canister with fresh water from
the tap up to the overflow. Now throw a Spülboy glass washing tab into
the pre washing canister (canister with brushes).
Open the faucet and adjust the water pressure.
The pressure is optimal if the horizontal water jets
meet in the middle. Now the NU is ready to start.
Please check all glasses on residues (straws,
limes, etc.) before washing. Scrub the glass up and down at least 4-6
times - don’t twist. Afterwards rinse the glass for minimum 3 seconds to
wash away the foam of the detergent.
5 decommission and daily cleaning
In case of daily use please clean your NU after decommission. Take
out the overflow pipe in order to drain off the water. Take out the
washer from the sink, remove the brushes and
place them in the sink. To disinfect the brushes we
recommend sprinkling 2 tblsp. of Spülboy
sanitation powder over both brushes. Fill up the
sink with hot water (40 –50 C°) and leave them for
at least 6 hours.
Now clean the Spülboy with a proper
sponge or cloth.