92-SA-1008-03
For additional assistance or service please contact:
SPEAKMAN®Company
400 Anchor Mill Road
New Castle, DE 19720
800-537-2107
www.speakman.com
SA-1008
SA-1008-KN
MAINTENANCE
Your new Speakman Product is designed for years
of trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. The use of
harsh chemicals and abrasives on any of the
Speakman custom finish products may damage the
finish and void the product warranty. Please be sure
to only use approved cleaners. Please contact
Speakman for any clarification of acceptable
cleaners.
WARRANTY
Additional warranty information can be found at:
www.speakman.com
Phillips
Screwdriver
Flat Tip
Screwdriver
Drill Tile Drill Bit
1/4”
Drill Bit
1/4”
Pencil
HELPFUL TOOLS & SUPPLIES:
Measuring
Tape
SAFETY TIPS
• Cover your drain to prevent loss of parts.
• This item is NOT designed for use as a grab bar.
Do not mount in locations where product is likely to
be used as a grab bar.
• Be sure to read instructions thoroughly before
beginning installation.
• Do not over-tighten any connections or damage
may occur.
• Instruction images shown are for reference only
and apply to all models numbers shown.
1• Loosen, but do not remove the Set Screw from
the base of the product post (1) with a Flat Tip
Screwdriver.
• Place the product in the desired mounting
location and use a Pencil to lightly mark the
outline of the post.
• Center the Mounting Bracket within the
marked post location and mark where the
screw holes will be drilled (2).
Mounting Bracket
13/16”
[21mm]
2If mounting directly to wood stud, Plastic
Anchors are not required. If mounting to tile,
acquire proper mounting hardware capable of
supporting the accessory in use. If mounting to
drywall, drill guide holes at marked locations
using a Drill equipped with a Ø1/4" bit.
Ø1/4"
3Insert Plastic Anchors into drilled holes and screw
in the Anchor using a Phillips Head Screwdriver,
or a Drill equipped with a Phillips Driver Bit until
the head is flush with the wall surface.
OR
