Spectra APR-PRT1 User manual

PRINTERBUSMODULE(APR-PRT1)
USER’SGUIDE
Introduction
The Printer Bus Module provides you with
the ability to manually print specific events
that have occurred in your Spectra system.
The events can be printed through a dot
matrix printer connected to the module’s
parallel port or its serial port.
Setting APR-PRT1 Time & Date
When the Printer Bus Module is connected
to a Spectra system, the module’s internal
clock must be set manually. To do so:
1. Press [ENTER]from your Spectra keypad.
2. Enter your [MASTERCODE].
3. Enter section [110].
4. Enter the 4-digit [YEAR](Ex: 2000, etc.).
5. Enter the 2-digit [MONTH].
6. Enter the 2-digit [DAY].
Example: You wish to set the date as June
4, 2000. After entering section [110], you
would enter: 2000 (year), 06 (month) and 04
(day). If the keypad emits a rejection beep,
there is an error. If so, try again.

Manually Printing System Events
The Printer Bus Module gives you the ability
to manually print specific system events that
have occurred. For example, you wish to
print a report of all the Arming and Disarming
events (all the times that your Spectra
system has been armed and disarmed) that
have already occurred in your system. To do
so:
1. Press [ENTER]from your Spectra keypad.
2. Enter your [MASTERCODE].
3. Enter the 3-digit [SECTION](See Table 1).
4. Press [ENTER].
Upon completing Step 4, the Printer Bus
Module will commence printing all the
system events that have occurred.
* = [PG]& [FNC1] keys pressed, Button
pressed on Remote, Bypass programming,
User Activated PGM, Breaching Zone w/
Delay and System power up.
Table 1: System Event Sections
Section System Events to be printed
[111] Arm & Disarm Events
[112] Alarm & Alarm Restore Events
[113] Tamper & Tamper Restore Events
[114] Trouble & Trouble Restore Events
[115] Miscellaneous Events*