Spectrum Industries 95044 User manual

Assembly Instructions
0193936 Page 1 of 2
Assembly Instructions
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts or
accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Locking Door for Aspire Workstation
95044
Assembly tip: Do not tighten component fasteners completely
until all have been installed. Keeping them loose will help with
alignment between parts during assembly.
(1) 0176828
Locking door
(2) 0119468
Recessed
bumper
(8) 0190174
#8 x 3/8” PHMS
Lower shelf
1. The shelves are included with theAspire Workstation. Make sure the
lower shelf is installed using the 3rd set of holes from the bottom.
1
Lower
Shelf
3rd set of
holes from
the bottom
Install door catch
1. Attach the door catch with (2) screws and tighten securely.
2
(1) 0176910
Door catch
Door catch
(2) #8 x 3/8”
PHM screws

0193936 Page 2 of 2 © 2023 Spectrum Industries Inc., All rights reserved.
1500 RIVER STREET, PO BOX 400, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
Install door
1. Open the door hinge and align the hinge mounting holes with the (4)
base panel mounting holes.
2. Attach the hinge with (4) screws and tighten securely.
3. Close the door and check the operation of the lock hasp to ensure
the hasp fully engages with the slot in the door catch. The catch can
be adjusted with the fastener slots if necessary, then retightened..
3
Install bumpers
1. Install the (2) recessed bumpers under the door. (1) screw each.
4
(2) #8 x 3/8”
PHMS
Door
(4) #8 x 3/8”
PHMS
(2) Recessed
bumper