Spectrum Industries 55386 User manual

Assembly Instructions
0120357 Page 1 of 2
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt. To
report information regarding missing parts or damage, to purchase parts or acces-
sories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Keyboard Tray
for MM-Link, MM-Director
55386
(1) 0120759
Keyboard Tray
Assembly
(4) 0100167
8-32 x 1/2” PH
Thread-cutting screw
1. Align mounting holes
1. Set the keyboard tray onto the mid-panel and align the 4 mounting
holes. Figure 1A. (If installing on Media Director models-see
Figure 1B).
Figure 1A
Note: On Media Director models, three different mounting
positions are available for the tray. (Left, centered, or right).
Mid-panel
Tools
Required
Phillips
Screwdriver
Figure 1B
Left
Centered
Right
Keyboard Tray

0120357 Page 2 of 2
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2016 Spectrum Industries Inc., All rights reserved.
2. Install Screws
1. Open or remove the door(s) to access the mounting holes under the
tray. (The rack cube can also be removed for improved access).
2. From inside the lectern, install the (4) 8-32 x 1/2” PH Thread-cutting
screws through the mid-panel mounting holes to secure the tray,
and tighten securely. Figure 2.
Figure 2
Tools
Required
Phillips
Screwdriver
8-32 x 1/2” PH
Thread-cutting screw
(4 required)
Keyboard Tray
Flipping Keyboard Tray / Drawer - Optional
1. To ip, pull the tray out fully and locate the black plastic lever
on each slide. Figure 3.
2. Release the levers on the both slides while pulling the tray out.
3. Flip the tray over, re-align the slides, and push back in.
Note: Can be used as a keyboard tray, or ipped and used as a drawer.
Figure 3
Push here on both
slides to release
Keyboard Tray