SpeechWare FlexyMike FMK03 Instruction manual

Connection of theFlexyMike Bluetooth Transmitter (FMK03)
under Windows Vista or Windows 7
(without any other third party software!)
1. BASIC OPERATING INSTRUCTIONS
Our models FMK03 (http://www.speechware.be/en/verArticulo.php?id=1671) --and FMK04-- feature a
couple of Light Emitting Diodes (LEDs), which lights up in Blue ( B-LED ) and Red ( R-LED ) colour, with
the following meaning:
•
••
• B-LED flashing twice quickly every 2 sec.: Power On and "Standby" (low consumption) mode
•
••
• B-LED flashing once slowly every 2 sec.: "Link" (transmission) mode
•
••
• B-LED / R-LED flashing alternatively: "Pairing" mode to establish a connection for the first time
•
••
• R-LED flashes quickly (while using it): Low battery mode
•
••
• R-LED lights on: Charging mode
•
••
• R-LED flashes twice quickly and stops: Power Off mode.
2.INSTALLATION OF FULL DUPLEX BLUETOOTH TRANSMITTER (FMK03) UNDER
WINDOWS VISTA OR WINDOWS 7 (WITHOUT ANY THIRD PARTY SOFTWARE)
a) Put the FlexyMike Bluetooth Transmitter in "Pairing" mode (check above): press the On/Off
button for about 5 s. and until the B-LED / R-LED flash alternatively. Make sure that before you
press the On/Off button, the Transmitter is Off.
b) Check for the Bluetooth icon of your Windows bar ( in the bottom right hand corner of your screen):
If you cannot see it, then Bluetooth may be disabled. To enable it, select Start > Control Panel >
Wireless Assistant and press enable (“Allumer”) Bluetooth in your computer:

If you do not see a Bluetooth item in your Control Panel, it may need to be installed!
c) Right-click on the aforementioned Bluetooth icon of your Windows bar, and select the option “Add peripheral”
(“Ajouter un périphérique”):
d) When the Bluetooth Transmitter (FMK03) is automatically detected by Windows Vista or 7, after a couple of
minutes, itappears in this screen. Click next:
e) In this screen, left-click or select the second option:

f) Insert the pin number "1234" and press “Submit”:
g) Click “Fermer” in the last window:
Now, your FlexyMike Bluetooth microphone is ready to be used under Windows Vista or 7!
3. HOW TO CONNECT AGAIN THE FULL DUPLEX BLUETOOTH TRANSMITTER (FMK03)
WHEN RESTARTING THE PC
If you need to establish again the Bluetooth connection, afterrestarting the PC,follow the next steps:
a) With the Bluetooth Transmitter switched On, right-click on the Bluetooth icon of Windows bar and
select now “Show the Bluetooth peripherals” (“Afficher les périphériques Bluetooth”):

b) Double-click on the SpeechWare microphone icon:
c) If there is no connection, in the next window, press “Connect” (“Connecter”)
d) When the connexion is established again, the window will show it: