ST-Lab C-440 User manual

eSATA/USB 1-Port ExpressCard
User Manual
Ver. 1.00
All brand names and trademarks are properties of their
respective owners.

MN7000000065 Page2
Features and Benefits
General
Fully compliant with ExpressCard Specification 1.0
ExpressCard/34 Form Factor Module
Works with various brands of SATA or USB 2.0 devices
Hot-swapping feature allows to connect or disconnect devices
without powering down system
Support Windows® 2000, XP/2003/Vista (32-bit and 64-bit)
SATA
Serial ATA generation 2 transfer rate of 3.0Gbps
Support SATA II NCQ (Native Command Queuing) to maximize
system performance
Supports hot plug for external Serial ATA port
USB
Fully supports EHCI and OHCI Compliant standards
Compliant with Universal Serial Bus specification revision 2.0
Supports USB 2.0 and USB 1.1 devices
Supports data transfer rates of high-speed (480Mbps), full-speed
(12Mbps), and low-speed (1.5Mbps)

MN7000000065 Page3
System Requirements
Windows® 2000, XP/2003/Vista (32-bit and 64-bit)
ExpressCard-enabled system with an available ExpressCard slot
Package Contents
1 x eSATA/USB 1-Port ExpressCard
1 x Driver CD
1 x User Manual
Hardware Installation
General instructions for installing the card are provided below. Since
the design of system may vary, refer to your system’s reference manual
for further information, if needed.
Insert the Card into the ExpressCard slot of your system. Make sure it
is inserted all the way in for a solid connection.
Driver Installation
1. Please insert the CD driver bound with eSATA/USB 1-Port
ExpressCard into your CD-ROM Drive.

2. At the Windows desktop, click Start, Run.
3. Type D:\ExpressCard\SiI3531\Setup.exe, click OK.
(Change D: to match your CD-ROM drive letter)
4. Follow the on-screen instructions to complete the installation.
To Verify Driver Installation
1. Right click My Computer and click Manage.
2. Select Device Manager.
3. Look for the following:
Windows® 2000/XP/2003: Double click SCSI and RAID
Controller:
-Silicon Image SiI 3531 SATA Controller should be displayed
Windows® Vista: Double click Storage controllers:
-Silicon Image SiI 3531 SATA Controller should be displayed