Stanley PJMM-2465C User manual

10
The Wall the Projector will be mounted on is either concrete or dry wall
with wood studs.

M4x25 (x4)
A
M5x25 (x4)
B
M6x25 (x4)
C
G (x4) H (x4) I (x4) J (x4)
D (x4)
Wall Screw
E (x4)
Wall Anchor
F (x4)
Washer
M8x50 (x5)
N
M8 (x5)
L
M5x6 (x2)
K
M5x12 (x4)
P
M (x10）
Washer
Q (x4)
Assembly the PJ Mount itself
For attaching Projector to Mount
O (x1)
Tool
Ceiling plate
Connection tube
Extension tube
Mounting plate

Insert the Connection Tube to
the Ceiling Plate,and align the
Ceiling Plate and the connection
tube , insert 3 bolts(N) through
the washers and tighten nut
with a spanner.
Insert the Extension Tube to
the Connection Tube,align
Extension Tube to the
Connection Tube,insert 1
bolt(N) through the washers
and tighten nut with a spanner.
Tools Required :

Use ceiling plate as template
making 4 marks with pencil
to show where to drill the
pilot holes.
Remove the ceiling plate,
drill the 4 pilot hole with a
3/8” drill bit ( hole depth
2”/ 50mm ).
Insert the plastic anchors(E) into
the 4 pilot holes .Tap gently with
a hammer.
Align the Ceiling Plate with
the 4 pilot hole and anchors,
insert 4 bolts(D) through the
washer into the anchors and
tighten.
3
4
2
3/8’’
#2 #4

Use a stud finder to locate a
ceiling joist.Then draw a horizontal
line on the center of the stud.
Use the ceiling mount as a
template aligning it with the
center of the stud. Make 4 pencil
marks to show where to drill.
Remove ceiling plate, drill the 4
pilot holes with a 3/16” drill bit
(hole depth 2”/50mm).
Align the Ceiling Plate with the
4 pilot hole , insert 4 bolts(D)
through the washer into the pilot
holes and tighten.
3
4
2
3/16’’
#3 #4

Align the 4 Extension plates with
the Wings of mounting plate.
Insert the 4 screws(P) through
the square washers(Q) and
tighten.
2

Check what screws will fit in
you projector (A,B,C).
Align the mounting plate onto
the top of the projector and
install with the appropriate
hardwares.
Note :if your projector has a
curved top you may need to
use the longer screws with
corresponding spacers.
2

Lift the projector with the mount
plate and insert the short
connection tube on the top of
mounting plate into the extension
tube.
Align the Extension Tube to the
short connection tube on the top
of mounting plate, insert 1 bolts
through the washers and tighten
nut with a spanner.
Use the two set screws(K) to
tighten the extension tube
against the connection tube.
3
2
mount plate