StarTech.com SAT3510U2V User manual

SAT3510U2V
3.5” USB 2.0 SATA Aluminum HD Enclosure

FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which the receiver•
is connected.
Consult the dealer or an experienced radio/TV technician for help.•
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other protected
names and/or symbols of third-party companies not related in any way to StarTech.com. Where
they occur these references are for illustrative purposes only and do not represent an endorse-
ment of a product or service by StarTech.com, or an endorsement of the product(s) to which
this manual applies by the third-party company in question. Regardless of any direct acknowl-
edgement elsewhere in the body of this document, StarTech.com hereby acknowledges that all
trademarks, registered trademarks, service marks, and other protected names and/or symbols
contained in this manual and related documents are the property of their respective holders.

Instruction Manual
i
Instruction Manual
Table of Contents
Introduction.................................................................................... 1
Features ......................................................................................1
System requirements...................................................................1
Package contents ........................................................................1
Hardware Guide ............................................................................. 2
Installation...................................................................................... 3
Technical Specifications............................................................... 6
Technical Support........................................................................7
Warranty Information ...................................................................7

Instruction Manual
1
Introduction
Thank you for purchasing a StarTech.com SAT3510U2V InfoSafe 3.5”
USB 2.0 SATA Aluminum Hard Drive Enclosure. This cost-effective stor-
age solution suits a wide variety of applications including file and applica-
tion sharing between desktop and notebook computers, data archiving, or
simply backing up existing hard drives to preserve data security.
Features
LED indicators provide easy monitoring of power status and hard drive•
activity
Power On/Off switch - allows you to conserve energy while the drive is•
not in use.
Supports 3.5” SATA II (SATA 300) and I (SATA 150) hard drives•
System requirements
3.5” SATA (SATA I, SATA II) hard drive•
An available (nearby) power outlet•
A host PC or Mac computer system with an available USB port•
Package contents
1 x Aluminum HD Enclosure
1 x Instruction Manual
1 x Screw Kit
1 x Plastic Stand
1 x USB (A-B) Cable

Instruction Manual
2
Hardware Guide
Rear Panel View
3
4
5
Front Panel View
Power/Activity LED1.
Power/Activity LED2.
DC 12V Power Adapter Port3.
On/Off Switch4.
USB type B Port5.
Screw Kit Power Adapter
Plastic Stand
USB A-B Cable
1
2

Instruction Manual
3
Installation
Remove the Rear Panel, to expose the internal SATA connections:1.
Position the hard drive you wish to install such that the SATA2.
connection is facing towards the SATA interface connector provided by
the SAT3510U2V front panel:

Instruction Manual
4
With the hard drive connected to the rear panel, turn the drive over3.
to expose it’s base. Fasten the hard drive to the front panel rails on
both sides, using the screws provided (2):
Fasten the front panel (with drive attached) to the body of the4.
enclosure; be cautious that the drive and front panel are properly
aligned with the body of the enclosure, to prevent damage to the LEDs.

Instruction Manual
5
Fasten both sides of the case to lock the hard drive in place:5.
Fasten the rear panel to the drive enclosure on both sides using the6.
screws (2) provided.

Instruction Manual
6
Once the drive has been secured within the enclosure, connect the DC7.
12V power adapter to the power adapter port. Connect the remaining
end of the power adapter to an available power outlet.
Connect the USB A-B cable to the USB B port on the rear panel of the8.
enclosure, then connect the remaining end of the cable to the host
computer.
With the host computer powered on, power on the drive enclosure9.
using the On/Off switch. The operating system will detect the presence
of the added drive, following which you will be able to properly format/
partition the installed drive from within the operating system.
Technical Specications
Bus Type USB 2.0
Maximum Date Transfer Rate 480 Mbps
Enclosure Casing Material Aluminum
Power Adapter 12V 2A
LED Indicators
Solid Green -Power status
Blinking Green - Read/Write Drive
Activity
Drive Capacity Maximum Up to 1 Terabyte
Chipset SunPlus SPIF215A
OS Support Support Window 98/ME/XP/Vista,
Mac OS 9.0 and up, Linux
Product Dimensions (L x W x H) 193 mm x 113 mm x 31 mm
(7.6” x 4.45” x 1.22”)
Product Weight 325 g (11.47 oz )

Instruction Manual
7
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commit-
ment to provide industry-leading solutions. If you ever need help with your
product, visit www.startech.com/support and access our comprehensive
selection of online tools, documentation, and downloads.
Warranty Information
This product is backed by a one year warranty. In addition, StarTech.com
warrants its products against defects in materials and workmanship for the
periods noted, following the initial date of purchase. During this period,
the products may be returned for repair, or replacement with equivalent
products at our discretion. The warranty covers parts and labor costs only.
StarTech.com does not warrant its products from defects or damages aris-
ing from misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA
LLP (or their officers, directors, employees or agents) for any damages
(whether direct or indirect, special, punitive, incidental, consequential, or
otherwise), loss of profits, loss of business, or any pecuniary loss, arising
out of or related to the use of the product exceed the actual price paid for
the product. Some states do not allow the exclusion or limitation of inciden-
tal or consequential damages. If such laws apply, the limitations or exclu-
sions contained in this statement may not apply to you.