StarVR H7101 User manual

Head Mounted Display QUICK GUIDE
GUIDE RAPIDE de l’afchage porté sur la tête / GUIDA RAPIDA DELLO Schermo montato sulla testa (HMD)
Head Mounted Display KURZANLEITUNG / GUÍA RÁPIDA del Pantalla del casco de realidad virtual
ヘ ッド マウント ディスプレイ クイック ガ イド / 머리 착용 디스플레이 빠른 시작 설명서
頭戴式顯示器快速指南 / 头戴式显示器快速指南

WHAT’S IN THE BOX?
HMD Tracker Holder 5m Type-C Cable
2 x 0.5m DP Cable 2 x 0.5m
USB Type-A Cable 1 x Power Adapter
(ADP-18TB C or ADP-18HW B)
2 x Secure Cable Holder Cable Adapter Cable Adapter Anti-Slip Mat

CONNECTING THE HMD - STEP 1
Type-C Cable
Type-C Cable

CONNECTING THE HMD - STEP 2
Type-C Cable
Cable Adapter

SECURING THE CABLE CONNECTOR
Secure Cable Holder

CONNECTING THE HMD - STEP 3
1
1
2
2
3
3
DP Cable
USB Cable
DP Port
USB Port
Power Connector
Power Cable

CONNECTING THE HEADPHONE
HMD Audio Cable
Headphone Audio Cable

MOUNTING THE TRACKER TO THE HMD
Screws
Tracker Holder
Tracker

APPLYING CABLE ADAPTER
ANTI-SLIP MAT
Back of Cable Adapter
Anti-Slip Mat

Radio Frequency Interference
Warning
For safety reasons, turn off all wireless or radio transmitting
devices when using your laptop under the following conditions.
These devices may include, but are not limited to: wireless LAN
(WLAN), Bluetooth and/or cellular.
The wireless adapter, like other radio devices, emits radio
frequency electromagnetic energy. The level of energy
emitted by the wireless adapter, however, is less than the
electromagnetic energy emitted by other wireless devices
such as mobile phones. The wireless adapter operates within
the guidelines found in radio frequency safety standards and
recommendations. These standards and recommendations
reect the consensus of the scientic community and result
from deliberations of panels and committees of scientists
who continually review and interpret the extensive research
literature.
In some situations or environments, the use of the wireless
adapter may be restricted by the proprietor of the building or
responsible representatives of the applicable organization.
Examples of such situations may include:
• Using the wireless adapter on board airplanes, or
• Using the wireless adapter in any other environment where the
risk of interference with other devices or services is perceived
or identied as being harmful.
If you are uncertain of the policy that applies to the use of
wireless adapters in a specic organization or environment
(an airport, for example), you are encouraged to ask for
authorization to use the adapter before you turn it on.
USA — FCC and FAA
The FCC with its action in ET Docket 96-8 has adopted a
safety standard for human exposure to radio frequency (RF)
electromagnetic energy emitted by FCC certied equipment.
The wireless adapter meets the Human Exposure limits
found in OET Bulletin 65, supplement C, 2001, andANSI/
IEEE C95.1, 1992. Proper operation of this radio according
to the instructions found in this manual will result in exposure
substantially below the FCC’s recommended limits.
• The following safety precautions should be observed:
Do not touch or move antenna while the unit is transmitting
or receiving.
• Do not hold any component containing the radio such that
the antenna is very close or touching any exposed parts of
the body, especially the face or eyes, while transmitting.
• Do not operate the radio or attempt to transmit data unless
the antenna is connected; this behavior may cause damage
to the radio.
• The use of wireless adapters in hazardous locations is
limited by the constraints posed by the safety directors of
such environments.
• The use of wireless adapters on airplanes is governed by the
Federal Aviation Administration (FAA).
• The use of wireless adapters in hospitals is restricted to the
limits set forth by each hospital.
FCC radio frequency interference requirements
This device complies with Part 15 of the FCC Rules. Operation
of the device is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference that may
cause undesired operation.
15.21
You are cautioned that changes or modications not expressly
approved by the part responsible for compliance could void the
user’s authority to operate the equipment.

Interference statement
This wireless adapter and HMD have been tested and found
to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in
a residential installation. This wireless adapter generates,
uses, and can radiate radio frequency energy. If the wireless
adapter is not installed and used in accordance with the
instructions, the wireless adapter may cause harmful
interference to radio communications. There is no guarantee,
however, that such interference will not occur in a particular
installation. If this wireless adapter does cause harmful
interference to radio
or television reception (which can be determined by turning
the equipment off and on), the user is encouraged to try to
correct the interference by taking one or more of the following
measures:
• Reorient or relocate the receiving antenna of the equipment
experiencing the interference.
• Increase the distance between the wireless adapter and the
equipment experiencing the interference.
• Connect the computer with the wireless adapter to an
outlet on a circuit different from that to which the equipment
experiencing the interference is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
RF exposure – SAR Information
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
2. This equipment complies with FCC RF radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum
distance of 0 centimeters between the radiator and your
body.
Canada — Industry Canada (IC)
This device complies with Industry Canada’s licence-exempt
RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables
aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
CAN ICES-3(B)/NMB-3(B)
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1)
l’appareil ne doit pas produire de brouillage,et (2) l’utilisateur
de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.
CAN ICES-3(B)/NMB-3(B)
Under Industry Canada regulations, this radio transmitter may
only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
Conformément à la réglementation d’Industrie Canada, le
présent émetteur radio peut fonctionner avec une antenne
d’un type et d’un gain maximal (ou inférieur) approuvé pour
l’émetteur par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectrique à l’intention des autres
utilisateurs, il faut choisir le type d’antenne et son gain de
sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.)
ne dépasse pas l’intensité nécessaire à l’établissement d’une
communication satisfaisante.
IC RF Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 0 cm
between the radiator & your body. This transmitter must not be
co-located or operating in conjunction with any other antenna
or transmitter.
Déclaration d’exposition aux radiations:
Cet équipement est conforme aux limites d’exposition aux
rayonnements IC établies pour un environnement non contrôlé.
Cet équipement doit être installé et utilisé avec un minimum
de 0 cm de distance entre la source de rayonnement et votre
corps.
Temperature:
- Operating : 5°C to 40°C
- Storage: 20°C to 60°C
Humidity (Non-Condensing):
- Operating : 20% to 80%
- Storage: 20% to 60 %

STARVR SUPPORT
USA: [e-mail]
EUROPE: [e-mail]
CHINA: [e-mail]
TAIWAN: [e-mail]
STARVR WEBSITE
VISIT US: https://www.starvr.com/
FOR DEVELOPERS: https://www.starvr-developer.com/
COPYRIGHT & TRADEMARKS
© 2017 STARVR Corporation. All rights reserved.
Version 1.0 issued on November of 2017.
The STARVR™ Logo is a registered trademark or trademark of Starbreeze VR AB.
All use is duly authorized through license.
TM

DECLARATION OF CONFORMITY
STARVR CORPORATION
25F, 88, Sec. 1, Xintai 5th Rd. Xizhi,
New Taipei City, Taiwan
We, STARVR CORPORATION
25F, 88, Sec. 1, Xintai 5th Rd. Xizhi, New Taipei City, Taiwan
Contact Person: Mr. Eric Lin, E-mail: [e-mail]
And, Acer Italy s.r.l.
Via Lepetit, 40, 20020 Lainate (MI) Italy
Tel: [phone] ,Fax: [phone]
www.acer.it
Product: Head mounted display
Trade Name: StarVR
Model Number: H7101
SKU Number: SH500
We, STARVR CORPORATION, hereby declare under our sole responsibility that the product described above is
in conformity with the relevant Union harmonization legislation: Directive 2014/53/EU on Radio Equipment, RoHS
Directive 2011/65/EU. The following harmonized standards and/or other relevant standards have been applied:
 Electromagnetic compatibility (Directive 2014/30/EU)
 EN 55032:2015
 EN 61000-3-2:2014 Class D
 EN 61000-3-3:2013
 EN 55024: 2010+A1:2015
 EN 301 489-1 V2.2.0
 EN 301 489-3 V1.6.1
 EN 301 489-7 V1.3.1
 EN 301 489-17 V3.2.0
 EN 301 489-24 V1.5.1
 Radio frequency spectrum usage (Directive 2014/53/EU)
 EN 300 328 V2.1.1
 EN 302 291-1 V1.1.1
 EN 302 291-2 V1.1.1
 EN 300 440 V2.1.1
 EN 300 440-2 V1.4.1
 EN 301 511 V9.0.2
 EN 301 893 V2.1.0
 EN 301 908-1 V11.1.1
 EN 301 908-2 V6.2.1
 EN 301 908-13 V6.2.1
 Healthy and Safety (Directive 2014/35/EU)
 EN 60950-1:2006/A11:2009/A1:2010/A12:2011/A2:2013  EN 50360: 2001/A1: 2012
 EN 62209-1:2006
 EN 62209-2:2010  EN 62311:2008  EN 62479:2010  EN 50566:2013
 RoHS (Directive 2011/65/EU)
 EN 50581:2012
Operation frequency and radio-frequency power are listed as below:
2402-2480MHz < 10 dBm
Year to begin afxing CE marking: 2018.
1/22/2018
Eric Lin / Chief Operating Ofce
STARVR CORPORATION Date

Federal Communications Commission
Declaration of Conformity
STARVR CORPORATION
25F, 88, Sec. 1, Xintai 5th Rd. Xizhi,
New Taipei City, Taiwan
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. The following
local Manufacturer /Importer is responsible for this declaration:
Product: Head mounted display
Trade Name: StarVR
Model Number: H7101
SKU Number: SH500
Name of Responsible Party: Acer America Corporation
Address of Responsible Party: 333 West San Carlos St., Suite 1500
San Jose, CA 95110, U. S. A.
Contact Person: Acer Representative
Phone No.: 1-254-298-4000
Fax No.: 1-254-298-4147
January 22, 2018