Stealth STL-HHS-BIO User manual

Your Electronic
Lock is currently
set with the default
combination of:
1-2-3-4-1-2
MODEL: STL-HHS-BIO
Step 2: Pinch tabs together and slide out
battery compartment
Step 1: Twist key LEFT (counter-
clockwise) to open door
IMPORTANT! Test your new combination
several times with the door open to ensure
new combination is properly set before
closing and locking safe.
Step 4: Hold down button 1 until green
light turns on and lock beeps 2 times
Step 5: Enter your current 6 digit
combination - lock will beep 2 times
l Factory default is 1-2-3-4-1-2
Step 6: Enter your new 6 digit
combination - lock will beep 3 times
Step 7: Reenter your new 6 digit
combination - lock will chime
Use switch next to interior light to turn
silent mode on or o.
If you see a continuous red light on,
replace battery
Scanner can register up to 31 ngerprints
l Lock will go into standby after 10
seconds of inactivity
l Lock will freeze for 5 minutes after 5
wrong combination attempts
l Hold down biometric scanner button
until lock beeps 5 times
l Lock will reset to factory
combination of 1-2-3-4-1-2 and
erase all registered ngerprints
*If lock beeps 5 times, lock light ashes red, and
ngerprint scanner stays green, ngerprint was not
installed successfully. Restart from Step 8.
*If lock beeps 5 times, combination was not
installed successfully. Restart from Step 4.
Step 8: Press ONCE (do NOT hold) biometric
scanner button - lock will beep 2 times/lock
light and nger scanner will illuminate green
Step 9: Position nger fully on biometric
scanner - hold until lock chimes
Fingerprint installed successfully.
Step 3: Insert a 9V battery into battery
compartment & slide battery compartment
back into place
OPEN:
CHANGE YOUR COMBINATION:
SILENT MODE:
BATTERY LIFE:
OPERATING INFORMATION:
RESET LOCK:
BIOMETRIC SCANNER:
INSERT BATTERY:
Lock Instructions
1
Lock
Light Fingerprint Scanner
2 3 4
RECORD NEW COMBINATION HERE:
Step 1 Step 2
Step 9
Step 3
Biometric
Scanner Button
Red Interior Light
Silent Mode
Switch
Your new combination is now installed.

Handgun Hanger Safe Security Cable Instructions
Power Cable Installation
Step 1: Wrap cable around a secure object
and insert lock through the loop on the
other end of the cable.
To install power cable,
simply insert cord
into the power cable
hole and plug into an
outlet.
Step 2: Make sure bolt is in unlocked
position. Insert locking bolt into hole located
at the rear of the safe.
Step 3: Twist key to the RIGHT
(clockwise) to lock cable in place.
Remove key.
Your security cable is now installed.
*To unhook cable, insert key and
twist to the LEFT (counter-clockwise).
Remove lock.
Security
Cable Hole
Power
Cable Hole
Step 1
Unlocked
Key will only release while locked.
Locked
Step 2
Step 3