Steelcraft FLAT FOLD HIGH CHAIR User manual

08
KEEP INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE
Flat Fold high chair
series R237
Distributed by:
AUSTRALIA
BRITAX CHILDCARE PTY.LTD.
A Britax International company.
(Incorporated in Victoria)
A.B.N. 55 006 773 600
99 Derby Road, Sunshine,
Victoria 3020, Australia
Phone: [phone]
Fax: [phone]
Due to our continuing program of development, Britax reserves the right to alter the specifications,
colour or design without any further notice.
The Steelcraft trademark is the property of Britax Childcare Pty. Ltd-Australia.
The Britax trademark is the property of Britax Excelsior Limited - UK.
Visit the Britax website at: http:/www.britax.com.au or email us at [email protected]
Due to the variations in the style and design of our products the illustrations used in this instruction
booklet are generic.
12/06 c 2007 Copyright Britax Childcare Pty. Ltd. Australia.
NEW ZEALAND
BRITAX CHILDCARE NZ. Limited.
A Britax International company.
101 Diana Drive, Glenfield,
Auckland 9, New Zealand.
Phone: [phone]
Fax: [phone]
Each Steelcraft unit is thoroughly inspected in our Quality Assurance
department prior to delivery. In the unlikely case that you find any
material or workmanship that affects the units normal operation,
we will repair the unit free of charge within 12 months of purchase.
You are required to present your receipt as proof of purchase.
For all concerns with your product please contact our Customer
Service team.
CUSTOMER SERVICE
1300 303 330 - Australia
0508 688 822 - New Zealand
Please read all the information carefully before using this product.
This warranty does not apply to failure due to improper care,
or normal wear and tear caused by product use. We reserve the
right to inspect the unit. You may be charged for repairs if the product
has been damaged accidentally.
Warranty
4000816_D
4000816_D FlatFold HighChair.ind1-2 1-2 19/3/08 10:07:36 AM

02 07
READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR FUTURE
REFERENCE. THE CORRECT USE AND MAINTENANCE OF THIS PRODUCT
IS ESSENTIAL.
WARNING THE CHILD SHOULD BE SECURED IN THE HIGH CHAIR AT
ALL TIMES BY THE HARNESS, EITHER IN THE RECLINING OR UPRIGHT
POSITION. THE TRAY IS NOT DESIGNED TO HOLD THE CHILD IN THE CHAIR.
IT IS RECOMMENDED THAT THE HIGH CHAIR BE USED IN THE UPRIGHT
POSITION ONLY BY CHILDREN CAPABLE OF SITTING UPRIGHT UNASSISTED.
WARNING PREVENT SERIOUS INJURY OR DEATH FROM FALLS OR
SLIDING OUT. NEVER LEAVE YOUR CHILD UNATTENDED, DIRECT ADULT
SUPERVISION IS REQUIRED AT ALL TIMES.
WARNINGS
• Follow the manufacturer’s instructions.
• Always secure child with the harness.
• Use on a flat and firm surface and never use near stairs.
• Do not allow child to stand on the seat.
• Never carry the High Chair with the child in it.
• The weight of the child using this product should not exceed 15kg.
• Always ensure the tray is secure on the armrests, the tray is not designed to hold the
child in the chair.
• Do not use the High Chair without the tray.
• Do not use accessories other than those supplied and approved by Steelcraft.
• Discontinue using your High Chair should any part become damaged or broken.
• Double check assembly before placing child into High Chair.
• Always ensure electrical cords, heaters, barbeques, fireplaces and other hot objects are
guarded or out of reach.
• Do not store outdoors.
• Always keep your child in view while in the High Chair.
• Always apply the brakes when using the High Chair.
• When making adjustments to the High Chair, ensure that you and your child’s body,
fingers and toes are clear of any moving parts on the High Chair, otherwise they may
be injured.
www.britax.com.au www.britax.com.au
NOTES
4000816_D FlatFold HighChair.ind3-4 3-4 19/3/08 10:07:37 AM

06 03
www.britax.com.au www.britax.com.au
PARTS LIST
A1 x Seat
B1 x Tray
C2 x Leg Tubes
1. ASSEMBLY
ATo open the high chair hold the leg tube and pull
outward until the rear legs lock, you will hear a click.
BInsert the front leg tube into the frame until the
press buttons lock. Repeat on rear leg.
2. TO SECURE YOUR CHILD
WARNING: Use this harness at all times.
A five-point harness is provided to restrain your child. To
secure the child in the harness, push buckle (A) and (B)
into the buckle housing (C) until the buckle prongs snap
into position. Carefully adjust the harness by pulling the
slider (D) until the desired snug fit is achieved in the lap,
shoulder and crotch straps. Always adjust the harness
when changing the seating position of the child. To
release the buckle, squeeze the top and bottom prongs.
AB
BB
CARE AND MAINTENANCE
To prolong the life of your nursery product keep it clean and do not leave it in direct
sunlight for extended periods. Trim may be cleaned using a damp sponge with soap
or mild detergent. Allow to completely dry preferably away from direct sunlight before
storing. In some climates the trims may be affected by mould and mildew. To help
prevent this occurring, do not store the product if it is damp or wet. Always store the
product in a well ventilated area. To maintain the safety of your nursery product,
check regularly and seek prompt repair for bent, torn, worn or broken parts. Use only
those parts and accessories approved by Steelcraft. Always check parts regularly for
tightness of screws and other fasteners - tighten if required.
THIS PRODUCT IS NOT INTENDED FOR COMMERCIAL USE.
A
B
C
4000816_D FlatFold HighChair.ind5-6 5-6 19/3/08 10:07:39 AM

04 05
www.britax.com.au www.britax.com.au
3. TO ATTACH TRAY
APull both left and right release latches located under
tray.
BAlign the tray with arm rests and slide to the desired
position. Release latches ensuring it has locked into
position. The position of the tray can be adjusted by
releasing latches and sliding the tray. To remove
release latches and pull tray away from seat.
WARNING DO NOT FORCE THE TRAY AGAINST THE
CHILD. USE THE THREE ADJUSTABLE POSITIONS.
BE SURE BOTH ADJUSTMENT FINGERS ARE
ENGAGED TO THE ARMREST.
4. TO RECLINE CHAIR
WARNING! DO NOT ADJUST WITH THE CHILD IN
THE CHAIR.
ASqueeze back-rest trigger together to adjust back-
rest downwards. To elevate squeeze back-rest
trigger together and push seat upwards.
5. TO REMOVE THE CHILD FROM HIGHCHAIR
ARelease tray and remove.
BRelease harness (see section 2) and remove child.
6. TO PLACE CHILD IN HIGHCHAIR
ARelease tray and remove.
BPlace child in seat and secure with harness
(see section2).
CSlide tray onto armrests.
7. TO FOLD THE HIGH CHAIR
WARNING! DO NOT ADJUST WITH THE CHILD IN
THE CHAIR.
APull up on the rear leg release latches. Lift rear of
frame and fold forward.
4000816_D FlatFold HighChair.ind7-8 7-8 19/3/08 10:07:41 AM