Stellar Lighting MK-12 RGBW User manual
www.stellarlighting.co.uk
1
MK-12 RGBW fibre optic light engine
User manual
Features:
•12WlightenginewithRGBWLEDlight
source
•Small size
•20mm port diameter
•RF remote
•Music rhythm sync mode
Technical specification
Light engine model
MK-12 RGBW
Programmes
Brightness, speed and voice control, 6 programs,
on/off
Remote controller
Yes, RF
Light source type
LED
CRI (Ra>):
70
IP rating
IP20
Light colour mode
RGBW
Working voltage
DC12V
Rated power
12 W
Material of housing
Aluminium
Light engine dimensions
115 mm (L) x 80 mm (W) x 37 mm (H)
0.35 kg
Remote control dimensions
85 mm x 52 mm x 7 mm
Fibre optic port diameter
16-20 mm
Fibre optic bundle compatibility:
B-200-20, B-400-20
Lifetime
50,000 hours
Warranty
2 year
Package dimensions (excluding fibre optic bundle)
190 mm (L) x 130mm (W) x 60 mm (H)
Weight with packaging
0.5 kg
www.stellarlighting.co.uk
2
MK-12 RGBW fibre optic light engine
User manual
Safety notices
Electrical work safety advice and tips
●Make sure the input voltage is correct.
●Avoid placing the light engine in the rain or in moist areas. Please ensure that the light engine has
sufficient ventilation and is not placed in a completely sealed area.
●Do not open the LED light engine for inspection or re-wire the electronic circuits if you are not a
professional. Opening the light engine might void your warranty.
●Avoid any debris on top or around the light engine as it can cause poor heat dissipation.
●Avoid using the device above 40 C temperature.
DIY tips and safety advice
●This task will involve working at height. A safe system of work should be established and maintained, in
order to prevent injury.
●Consider your safety! Think about the potential risks and dangers of the work and the steps you should
take to avoid them.
●Personal protective equipment. Make sure that you are equipped with suitable and sufficient personal
protectiveequipment. Thiscouldinclude eyeprotection,face mask,protectiveoveralls, safetyfootwear
and gloves.
●Ensure that the work area is sufficiently illuminated.
●Check that the tools you will be working with are in a good operating condition. For the installation,
you will need a cordless drill, epoxy glue, side cutters or scissors and drill bits.
www.stellarlighting.co.uk
3
MK-12 RGBW fibre optic light engine
User manual
Connection method between optical fibres and the light engine
Your fibre optic bundle will come with the
connector fittings ready to connect to the
light engine. However, if you need to adjust
your bun
follow the steps below.
1. Align all the optical fibre ends and fasten with tapes which can resist temperature over 130℃
2. Pass the fibres through the connector and fasten the rotary tensioner until the fibres are tightened.
3. Cut the fibre bundle to a flat surface with a heat-knife or blade.
4. Make sure that the optical fibrebundle head is smooth and clean to ensureeven light distribution.
5. he . Fasten the bundle with
the screw on the top of the .
Other Stellar Lighting Lighting Equipment manuals
