Streamline K-2089-71FSWHSS-DM Troubleshooting guide

streamlinebath.com
QUESTIONS ON PRODUCT, INSTALLATION, RETURNS? PLEASE CONTACT
1 (310)-935-0028
[e-mail]
READ ENTIRE INSTALLATION GUIDE
PRIOR TO INSTALLING THE BATHTUB
THIS BATHTUB SHOULD ONLY BE
INSTALLED BY A CERTIFIED PLUMBER
CAUTION! TWO PEOPLE ARE REQUIRED
TO LIFT THE BATHTUB
FREESTANDING BATHTUB SERIES
OWNER'S MANUAL &
INSTALLATION GUIDE

These products must be installed by a fully insured and licensed plumber only.
Installation of any product by anyone other than fully insured and licensed plumber shall void limited warranty.
We are not responsible for any local code compliance for this product.
Building and plumbing codes may vary state-to-state.
Streamline shall not be held liable for any and all incidental damages or flood caused due to use of this product.
Streamline shall not beheld liable for any and all fees stemming from cost of installation, re-installation, removal,
subsequent damage, or transportation in a case of a product defect.
Silicone
Bathtub Flexible Hose
(pre-installed)
Adjustable Key Measuring Tape Safety GlassesPencil Level Bar
PRIOR TO INSTALLING
TOOLS REQUIRED
WHAT'S IN THEBOX

DIAGRAM
Cover
DESCRIPTION Qty.No.
Gasket
Gasket
Gasket
Core
Cap
Body
1
2
3
4
5
6
7
1
1
1
1
1
1
1
Flexible Hose
Drain Diameter: 1.5''
Pre-Installed to Bathtub
Overall Tube Length: 36''
1
2
3
4
5
6
7

BATHTUB INSTALLATION
1. Ensure that the floor at the installation site has sufficient floor support and is level.
2. Waterproofing the floor is highly recommended.
3. Determine the location of the drainpipe on the floor by taking measurements of the drain and waste
location underneath the unit. Clean the drain hole area in preparation of setting the drain. The area
should be dry & free from any debris.
4. Remove the bathtub from its box. It is recommended that the bathtub is carried by a minimum of
two people. Ensure to carry and set down the bathtub only in the upside-down position.

5. Lift and separate the resin bathtub from the panel frame.
6. Drill faucet holes and assemble the faucet according to according to the manufacturer's instructions.
7. Move the panel frame to desired installation location.
8. Proceed to place the provided flexible drain hose into the floor drain.

10. Seal the connection by using a PVC pipe sealant to join the parts together.
11. Lift and put the resin bathtub back into the panel frame, ensuring that the bathtub is level with the
panel.
12. If you are placing your bathtub against the wall, apply silicone sealant along the edges.
9. Please note, the flexible hose is a basic way that we provide to connect to the end plumbing in a
home. The plumbing installation in every home differs, so please consult with a certified plumber
to see if the plumbing in your home is compatible with using a basic flexible hose.