Streamline STREAMFLO-25 User manual

INSTRUCTION
MANUAL
Packed By
Checked By
Date Checked
CODES
SF-TR25-072
STREAMFLO-25™ TROLLEY
THE KIT INCLUDES
1 x STREAMFLO-25™ Trolley
1 x TDS Meter

2
Thank you for purchasing a STREAMLINE®
Water Filtration System
Your trolley has been assembled and tested to ensure that there
are no leaks and to ensure that the pump and pressure switch are
functioning correctly.
Enclosed is a TDS Meter which measures parts per million in water.
This enables you to test the water quality periodically to ensure that
your system is producing pure water, i.e. 0ppm, so as to achieve the best
cleaning results. We would recommend that a sample is taken from water which is being
pumped to the brush head on the water fed pole.
When cleaning windows, remember to pay special attention to the frames, especially if it is
the first time this method of window cleaning is being used. The most important part of the
cleaning process is the rinsing, after the window has been cleaned. To do this, lift the brush
away from the glass and move the head from side to side working from top to bottom,
allowing the water to create a sheet, therefore rinsing the glass. Extra care must be taken
if the water refuses to ‘sheet’, as this makes rinsing success-fully more dicult. If you are
cleaning windows on a warm day, the rinsing procedure must be done meticulously, as warm
direct sunlight can cause spotting due to insucient rinsing.
ONE YEAR
WARRANTY

3
INSTRUCTION MANUAL
CHARGING THE BATTERY
• To charge the battery, use the battery
charger supplied with the trolley.
• Connect the XLR plug into the
charging socket on the trolley and
connect the 3 pin plug to the mains
power supply.
• Charge the battery for approx 8 hrs.
• Further details relating to the charger
can be found in the instructions,
included with the charger.
• The battery must be charged
fortnightly, even if the trolley is not
being used. Failure to do this may
cause the battery voltage to drop and
minimise its charging capacity.
SETTING UP
• Remove the container lid’s and riser
tube and fill the container with
pre-filtered water. If the trolley is fitted
with a resin filter, fill the container with
tap water, provided the water hardness
is below 100ppm.
• Re-insert the riser tube and screw the
lid’s on securely.
• Care should be taken that the trolley
does not over-balance when only
one container is full of water. When in
operation the containers will empty
simultaneously.
• Switch the pump on by pressing
and holding the ‘
ˆ
’ button on the
STREAMLINE® flow controller, until the
display iluminates.
• Set the pump speed to 30 by pressing
the ‘
ˆ
’ or ‘
ˇ
’ buttons.
• Allow the pump to prime until water
flows out of the brush nozzle jets.
INSTRUCTIONS FOR USE
Charging socket
Filling the
25ltr tank

4
• Adjust the flow by using the up and
down arrows, according to the cleaning
operation on hand.
• When complete, switch the pump o
by pressing and holding ‘
‹
’.
MAINTENANCE
Filter Servicing (If fitted with this option)
Regular meter readings should be taken
using the enclosed TDS meter toensure that
the system is producing pure water. When
the water TDS no longer registers 000ppm
follow the servicing sequence below.
Changing the Resin
• Unscrew the resin filter from the back
of the trolley with a screw driver.
• Unscrew and remove the riser from the
filter and dispose of the old resin in a
responsible manner.
• Fill the vessel with new resin, to the top
of the label.
• Re-insert the riser and screw into
place. You may need to lift and shake
the vessel whilst pushing the riser into
place.
• Screw the resin filter bck onto the
trolley.
• Click the connector onto the filer and
your trolley is now ready for use again.
Used resin should be disposed of in a
responsible manner. If in douby you should
refer to your local waste collection service
provider.
TRANSPORTATION
Remove the container lid and riser tube.
Remove the water container. Loosen the two
locking nuts on either side of the handle and
lift an fold the handle forwards to enable
the trolley to fit into a confined space. Care
should be takn so as to avoid pinching of the
fingers when folding the handle.
Decrease
Pump Speed
Increase
Pump Speed
Fill up to
lling line
Replace riser

5
INSTRUCTION MANUAL
The warranty on Machines and Equipment
is for 1 year from RECORDED DATE OF
PURCHASE.
If VARITECH SYSTEMS receives notice of
such defects during the warranty period,
STREAMLINE® will either, at its opinion,
repair or replace components which prove to
be defective.
Replacement parts will only be supplied under
warranty, upon the inspection and approval of
the defective parts by STREAMLINE®.
Should it be necessary to supply replacement
parts before the opportunity to inspect, these
will be charged at current prices and credit will
only be issued upon subsequent inspection
and warranty approval by STREAMLINE®.
The customer is responsible for the cost of
return of the defective part. If warranty is
approved, STREAMLINE® will pay for the cost
of the repaired or replacement part.
REPLACEMENT PARTS SUPPLIED UNDER
WARRANTY WILL BE GUARANTEED
FOR THE REMAINDER OF THE ORIGINAL
PARTS WARRANTY AND NOT FROM THE
INSTALLATION DATE.
This warranty excludes the following conditions
and circumstances which are at the discretion
of STREAMLINE® :
WEAR AND TEAR, MISUSE, ABUSE, IMPROPER
MAINTENANCE, FROST DAMAGE, THE
USE OF CHEMICALS OTHER THAN THOSE
SUPPLIED OR APPROVED BY STREAMLINE®,
IMPROPER INSTALLATION OR REPAIR,
UNAUTHORISED MODIFICATION, INCIDENTAL
OR CONSEQUENTIAL COSTS, LOSS OR
DAMAGE, SERVICE, LABOUR OR THIRD
PARTY CHARGES, THE COST OF RETURNING
DEFECTIVE PARTS TO STREAMLINE®.
This warranty constitutes the exclusive remedy
of any purchaser of a STREAMLINE® unit
and is in lieu of all other warranties, express
or implied, including without limitation any
implied warranty of merchantability or fitness
for use, to the fullest extent permitted by
law. In no event shall any implied warranty of
merchantability or fitness for use exceed the
term of the applicable warranty stated above
and STREAMLINE® shall have no other
obligation or liability.
These rights cannot be transferred to a
third party.
Varitech Systems Hamilton House, 8 Fairfax Road,
Heathfield Industrial Estate, Newton Abbot, Devon
TQ12 6UD, UK
Call 01626 830830
Email [e-mail]
www.varitechsystems.co.uk
THIS WARRANTY EXCLUDES
NORMAL MAINTENANCE ITEMS,
including but not limited to HOSES,
FILTERS, O-RINGS, DIAPHRAGMS,
VALVES, GASKETS, CARBON
BRUSHES and damage to motors and
other components as a result of failure
to replace normal maintenance items.
THIS LIST IS NOT EXHAUSTIVE.
ISO9001 Cert. No. 9709
STREAMLINE® WARRANTY

6