STREET WISE SWAAB30 User manual

1Full Press: When fully pressed, you will hear a clicking sound. Rev
04/2023
SWAAB30Instructions
IMPORTANT: Before using we recommend that you take time to familiarize yourself with this unit. The key to
understanding how it operates is the “Function-Select Button (5).” Each time this button is pressed, the function changes
in the following order: Light, Stun, Off. To help you remember the order, the corresponding symbol is shown below the
Function-Select Button: for LIGHT, for STUN, and for OFF.
ADJUSTING THE STUN BATON
Note: The baton can be adjusted up to 19 inches long
1. With the handle in your right hand and the top half of the baton in your left, twist the handle slightly until you feel it loosen.
2. Twist the part of the stun baton labeled “Twist Lock”. Twisting all the way will lock it back into place. Move the top up or down until you
reach your desired length; it will stop when it reaches the maximum length.
3. Twist thehandle and the top half of the baton in the opposite direction to lock in place.
RECHARGING
1. The batteries charge while inside the unit and they are already installed so there isno need toremove them unless you want to replace the
rechargeable batteries. To access the batteries, turn the bottom of the handle counter clock wise.
2. We recommend charging the stun baton before itis used. To charge, fully press the Push-Button Tail Switch to turn on the unit. The
standby indicator light on the baton will turn green. Plug the charging cord into the Charging Port (6) in the middle of the baton and plug the
other end into a standard outlet. A red light on the base of the charger will illuminate while the unit is charging and then turn green when
fully charged. Charge for 8 hours. Then unplug the unit from the charging cord. IMPORTANT: do not charge for more than 8 hours at a
time. Overcharging can damage the unit and void the warranty. When used infrequently the unit will need tobe recharged for 8 hours every
60 days. If the flashlight is used frequently or if the electrical current or flashlight becomes noticeably weaker, the unit will need tobe
recharged.
USING THE FLASHLIGHT
Overview: This unit features three light strengths (Maximum, Medium, & Low) and two light patterns (SOS & Strobe). When the situation does
not require maximum light strength, the lower light settings can be used to extend the battery life.
1. Fully press1the Push-Button Tail Switch to turn on the unit. You will hear the button click and the green LED or the red and green LED will
come on indicating that the power to the unit is on. It will be in the same mode (LIGHT, STUN, or OFF) that it was in when it was turned off.
If only the green LED is on and you see the flashlight, you are in LIGHT mode. If only the green LED is on and you do not see the
flashlight, you are in OFF mode. If the green and red LED lights are on, you are in STUN mode. If you press the Push-Button Tail Switch
and the flashlight does not turn on see #3 below.
2. Once the flashlight turns on you can change the light mode by Half Pressing either the Push-Button Tail Switch or the Function-Select
Button. If you press either of these buttons too hard you will hear a click and the flashlight will turn off.
3. If you press the Push-Button Tail Switch and the flashlight does not turn on, then the Function-Select Button is either set to Stun or OFF
mode. If both the green and red LED lights are on, then it is in Stun mode. Fully press1the Function-Select Button two times to get to Light
mode. If only the green light is on, but the flashlight is not, it is in the OFF mode. Fully press1the Function-Select Button one time to get to
Light mode. To change the Light mode, see #2 above.
4. To turn off the light, fully press1either the Function-Select Button or the Push-Button Tail Switch.
5. If you turn the light off by fully pressing1the Push-Button Tail Switch, you will need to press this same button again to turn it on. If you turn it
off by fully pressing1the Function-Select Button, be careful to note that you are now in stun mode (red light will be ON) and pressing the
1. LED Flashlight
2. Stun Probes
3. Indicator Lights- Flashlight or Off: Green
Light Only. Stun Mode: Red and Green
4. Stun Activation Button
1
5. Function- Select Button (Light, Stun, OFF)
6. Charging Port (Backside-Not Shown)
7. Push-Button Tail Switch (Not Shown):
a. Full Press1turns unit ON/OFF.
b. Half Press changes light model
8. Twist Lock
3
4
6
5
7
2
8

1Full Press: When fully pressed, you will hear a clicking sound. Rev
04/2023
Stun Activation Button will activate the stun feature. To return to light function, you will need to fully press1the Function-Select Button two
more times.
TESTING THE STUN BATON
(WARNING: Do not test fire the stun baton for more than 1 second as this could damage the unit and void the warranty.)
1. Fully press1the Push-Button Tail Switch to turn on the unit. If both the red and green LED lights turn on it is in stun mode and ready to test
the stun baton. Go to #3 below. If only the green LED is on and the flashlight is on, it is in the Light mode. Fully press1the Function-Select
Button one time to move to the STUN mode. If only the green LED is on and the flashlight is off, it is in the OFF mode. Fully press1the
Function-Select Button two times to move to the Stun mode.
2. Be sure both the red and green LED lights are on to confirm it is in the Stun Mode.
3. Press the Stun Activation Button to test fire the unit. Do not hold the button down for more than 1 second. You will see and hear the
electrical current fire across the top of the unit between the contact probes.
4. Once your test is complete, fully press1either the Push-Button Tail Switch or the Function-Select Button to turn the unit off.
USING THE STUN BATON IN SELF DEFENSE
1. Before using the stun baton in self-defense, we recommend you become familiar with how this unit operates so
you can quickly protect yourself with the Stun Function. See How to Quickly Access the Stun Function below.
2. Using the directions above, move the unit into the Stun Mode.
3. Touch your assailant’s body with the contact probes and press the Stun Activation Button.
4. Touching anywhere on the assailant’s body will have an effect. However, the maximum effect is achieved in
the areas shown to the right:
5. When touching the assailant’s body, you will not see or hear the electrical current as you do when the unit is
test fired. You can hold the Stun Activation Button down for more than 1 second, as this will not damage the
unit, as it will when being test fired.
6. You do not have to be concerned about the effects of the charge being transferred to you.
Even if the assailant touches you while being stunned, you will not feel the effects of the charge.
HOW TO QUICKLY ACCESS THE STUN FUNCTION
1. When the Flashlight is on, fully press1the Function-Select Button then press the Stun Activation Button.
2. When the flashlight is not in use, we recommend leaving the Function-Select Button in the Stun position (with both the red and green LED
lights on) and fully pressing1the Push Button Tail Switch to turn the unit off. When you want to quickly use the Stun Function, fully press1
thePush-Button Tail Switch and then the Stun Activation Button.
EFFECTS OF THE UNIT ON AN ASSAILANT
1. Touching an assailant for less than 1 second will cause minor muscle contractions and have a repelling effect.
2. Touching an assailant for 1 to 2 seconds will cause muscle spasms and a dazed mental state.
3. Touching an assailant for 3 to 5 seconds will cause loss of balance and muscle control, total mental confusion, and disorientation. All
effects to the assailant are temporary; the stun baton can cause no permanent harm. NOTE: The device should not be used for longer
than 5 seconds.
WARRANTY
Cutting Edge Products, Inc. extends a lifetime warranty to the SWAAB30 against defects in materials or workmanship,
with the following exceptions:
1. The warranty does not cover damage resulting from accident, misuse or abuse, lack of reasonable care, moisture, the affixing of any
attachment not provided with the product, loss of parts, or recharging the unit in any manner not in accordance with the included
instructions.
2. The warranty will be voided if the unit has been opened or tampered with in any way (unless by an authorized dealer) or if any
unauthorized replacement parts have been used.
3. The batteries have a one-year warranty (as long as the charging instructions above have been followed). If you have problem with the unit
not functioning properly, we recommend replacing the batteries to see if that fixes it.
NOTICE
Purchaser must check and abide by all local laws governing the possession and use of stun batons. In addition, the stun batons must only be
used in a lawful manner for self-defense. NOTE: Not to be used on children, persons with heart disease, or any vital part of the human body.
Not to be stored or used in environments where it is damp or humid or where there are extreme hot or cold temperatures. Do not use on metal
objects.
CONDITIONS OF SALE
Purchase of this product is an agreement by the purchaser/user to hold all sellers and manufacturers harmless of all liabilities and damages.
TO OBTAIN SERVICE
Contact the Authorized Dealer from whom you purchased this unit for a Return Merchandise Authorization. The return unit must be sent postage
prepaid and proof of purchase is required. Damage or loss occurring during shipment is not covered by this warranty.