Stromberg Carlson Products LA-2022152 User manual

StrombergCarlson.com • 231.947.8600
PROUDLY MADE IN THE USA
INS-LA2022152-C 07.01.2022
Starter Ladder
Model: LA-2022152
Starter Ladder LA-2022152
FIGURE 1
Thank you for purchasing the Stromberg Carlson Starter Ladder.
When used properly, this product will provide many years of
trouble free service. This kit contains components and hardware
for one complete ladder extension. This ladder is to be mounted
to your RV’s exterior ladder when parked, to aid in climbing
your RV’s exterior ladder.
WARNING:
nBoth ladder feet must be firmly on the ground when
in use.
nCage pins must be securely attached around RV ladder
prior to use.
nDo not exceed an 10° - 13° angle when using this
extension ladder.
nDo not jump on this ladder extension.
nWeight restriction of 250 lb.
nDo not leave this attached to your ladder when
traveling.
nNever use without the locking cage pins securely in
place and be sure swivel top is tight and can not rotate.
nPeriodically inspect ladder for damage and if
damaged, do not use.
nDo not use while motor home is running. Exhaust
fumes can be a FIRE HAZARD.
nStromberg Carlson is not responsible for any damage
if warnings are not heeded.
Do not use unless the cage
pins are secured (Figure 1).
Both ladder feet must always
be in contact with the ground.
Installing this ladder at an
10° - 13° angle is recommended
(Figure 6). Never use in a
vertical position. Failure to
follow these instructions
could result in injury.
11"
11" wide center
line of each 1"
diameter tube.
(Can fit slightly
wider ladders.)
51-1/2"

Starter Ladder LA-2022152
StrombergCarlson.com • 231.947.8600
Tools Needed
#2 Phillips screwdriver
7/16” wrench
Carton Contents (Figures 2 & 3)
(2) pc 1” diameter x 51.5”
tubing with rubber
foot already installed
(3) pc ladder treads
(2) pc attaching brackets
(2) pc locking cage pins
(3) sets fasteners for treads
(6) pc 1/4” x 1-3/4” bolts
(6) pc 1/4” flat washers
(6) pc 1/4” nylon lock nuts
(2) sets of 1/4“ hex head bolts
(2) pc 1/4” locking washers
Scan here for
video showing
tread assembly
FIGURE 4 FIGURE 5
1. Using the 1/4” x 1-3/4” long bolts, 1/4” flat washers and 1/4”
lock nuts, attach the treads to the upright tubes.
(Figures 4 and 5)
• There is a slight divot in the side face of each tread. Use
this divot to face all treads in the same direction when
attaching to the tubes.
• The upright tubes have a slight bend to them. You should
tighten the treads to the uprights until they are square, but
do not over tighten as you could collapse the tube wall,
weakening the ladder.
2. Using the 1/4 bolt and lock washer, attach the locking top to
the ladder. Pressure is necessary to be sure the locking top
can not rotate. Serious injury can occur if tops rotate.
FIGURE 2
FIGURE 3
Please read all directions prior to installation.
When assembled and used properly, this ladder will provide
many years of trouble-free service. This kit contains components
and hardware for one complete starter ladder. Complete the
following easy steps and it will be ready for use.
51.5” 50.5”
9.8”
FIGURE 6
10º -13º
Diagram
sho ws 11º