sultan healthcare Moist SURE User manual

Moist SURE™Automated Dispenser REF 95762
INSTALLING DISPENSER ON WALLPLATE
Dispenser is shipped
with the center screw
attached (shaded).
This tab must be
removed when
dispenser is installed
on wallplate.
11a 1b
To install on
wallplate, open
dispenser as
shown.
2Wallplate
Dispensing
Volume
Place dispenser
over 4 latches at
bottom of wallplate.
3Push down
with thumb,
making sure
tabs lock below
reinforcing bar.
4
REMOVING DISPENSER
FROM WALLPLATE
To remove dispenser,
pry out tabs to clear
plastic reinforcement ribs
on wallplate. Then slide
dispenser up and pull off
of wallplate.
INSTALLING AND REPLACING BOTTLE
To open dispenser,
press down on top to
release side latches.
Dispenser cover will fall
open. If dispenser does
not open, slightly rock
dispenser side to side
while pressing down.
1
Set new bottle into
position and make
sure cap is seated
properly in cap
retainer.
4
View of
dispenser
side latches.
1a Close up of
dispenser cover
side latch.
1b
Rear View
Side View
Open dispenser.
2Snap off
and discard
protective
cover from
new bottle.
3Remove blue
vent plug.
Close cover.
5
66a Make sure
bottle tip
is properly
inserted into
center of hole.
7Dispenser
is now
ready to
use.
LOW BATTERY WARNING
The graphic on the front of the
dispenser will blink for 48 hours
when the batteries are low.
This indicates it is time to
change the batteries.
Requires 4 AA Alkaline Batteries
Open battery cases by unscrewing
counterclockwise and squeezing latch to pull
open. Spring end is negative (-) end of battery.
+
+
Battery Compartments
T652-INC(914) 62179 1 of 2
T652-INB
7/6/12 11:12am Rev8
SETTING DISPENSING VOLUME
The unit has three dispenser settings.
1) On the backside near the bottom
of the unit is a recessed switch to
control dispensed amounts.
2) When facing unit on the wall:
a. Setting to far left: Low
b. Setting to center: Medium
c. Setting to far right: High
3) Move switch to desired dispense setting.
Note: As a guideline the approximate volumes are
Low = 1.0mL Moist SURE Liquid Sanitizer,
Medium = 1.5 mL Moist SURE Hand Soap,
High = 2.0 mL.
Settings can be adjusted per user preference.
1c

2 of 2
WALLPLATE TEMPLATE
5.5" (13.9cm)
5.0" (12.7cm)
11.25"
28.6cm
7.95"
20.2cm
MOUNTING WALLPLATE WITH
ADHESIVE TAPE
Dispenser can be fastened to any smooth surface,
such as tiles, mirrors or walls.
Clean surface thoroughly with mild detergent and
water, if soil is visible. Dry completely.
(NOTE: Surface must be completely dry for tape
to adhere properly.) Wipe surface with rubbing
alcohol and let dry.
Adhesive tape sticks on contact. Peel protective
covering off self adhesive tape, then carefully
position wallplate. Press firmly for thirty seconds.
(NOTE: For maximum adhesive strength, allow
wallplate to set for 24 hours before installing
dispenser.) Do not attempt to reposition the
wallplate, this reduces the holding power.
12.5"
31.8cm
9.5"
24.13cm
1.0"
2.5cm
9.5"
24.13cm
Vent Plug
3"
7.6cm
Distance from wall 3.8" (9.7cm) when closed.
Side View
Dimensions
INSTALLING WITH SCREWS ONLY (No Wallplate Used)
The center screw hole must be used and the
backing tab must be folded back and used as
a filler so the dispenser is not bent in when
screwed to wall.
Then attach 2
screws in either
upper or lower
screw holes to
secure dispenser.
1 3
Rear View
2Center Screw Hole
Screw Holes
Dispenser Made in China0095762DF, R2-092914