BEFORE YOU START
This task is accomplished more easily with two people.
Gloves and goggles are recommended. No tools are required.
Identify all glass panels.
Identify the Z-clips.
Locate the W-clips from inside the greenhouse pack.
USING THE W-CLIPS TO SECURE THE GLAZING
The glazing is fixed with wire spring clips, also known as W-clips because of their shape.
Once the glass is in place, secure it with the W-clips as shown in the photograph.
Use three W-clips to each side of the largest panels and two for smaller panels.
The small panel in the middle of the door requires only one W-clip each side.
The W-clips should be a tight fit so a little pressure may be required to fix them in place.
The appearance will be neater if the clips are evenly spaced and symmetrical.
USING THE Z-CLIPS TO OVERLAP THE GLAZING
Two Z-clips are required between the higher and lower glazing panels at front and rear.
First slot the Z-clips over the top of the lower glazing panels.
Next, the higher glazing panels can be lowered into the Z-clips.
Once the glass panels are in place, secure them with W-clips
GLAZING THE ROOF VENT
The roof vent should be glazed during installation.
For further details please refer to the separate greenhouse erection instructions.
Summer Garden Buildings does not guarantee that this is the most recent version of these
instructions or that all data has been accurately reproduced. You are advised to refer to the
instructions supplied with the product before assembly. If for any reason the instructions are not
delivered with the product you are advised to obtain the most recent version before assembly.
No guarantee is given regarding the accuracy of these instructions and no liability will be
accepted for any errors or inaccuracies.
6ft (1.93m x 1.9
Our Help Line provides support and advice to customers of Summer Garden Buildings after ordering. For advice
before you buy you can phone us free 7 days a week on 0800 9777828 or visit www.summergardenbuildings.co.uk