Summer 3-in-1 Floor 'N More Support Seat User manual

3-in-1 Floor ‘N More Support Seat™
INSTRUCTION MANUAL
Thank you for purchasing the 3-in-1 Floor ‘N More Support Seat from Summer Infant.
This multi-use seat is designed to grow with your little one from approximately 4 months to
approximately 4 years of age, providing a safe place to sit, snack and play!
13630 13630Z
Please read the following instructions and
warnings carefully before using this product.
KEEP THIS INSTRUCTION MANUAL
AND SAVE FOR FUTURE REFERENCE.
Tool required: Phillips head screwdriver (not included).
For technical support, contact us at [phone].
or www.summerinfant.com/contact
For use with children from
approximately 4 months to 4 years (see page 7).
Adult assembly required.

2
WARNING
FALL HAZARD: Infants have suffered skull fractures falling while in and from floor seats:
·Use ONLY on the floor.
· NEVER use on an elevated surface.
· ALWAYS use restraints. Adjust to fit snugly.
· NEVER lift or carry child in the product.
· Use ONLY with a child that is able to hold their head up unassisted.
· STOP using when child can climb out or walk.
· ALWAYS keep child in view while in product.
DROWNING HAZARD: Infants have drowned when floor seat has been placed in a bath tub or pool.
· NEVER use in or near water.
· Discontinue use of the product if damaged, broken, or disassembled.
Children have suffered head injuries, including skull fractures, after falling with or from booster seats.
· Check that booster seat is securely attached to adult chair before each use.
· Always use restraints until child is able to get in and out of booster seat without help. Adjust to t snugly.
· Never allow child to push away from table.
· Never lift and carry child in booster seat.
· Stay near and watch your child during use.
· ALWAYS secure BOTH back and seat straps to an adult chair.
· NEVER leave child unattended and without supervision.
· Prevent serious injury or death. Do not use in motor vehicles.
· NEVER use this product as a car seat or bath seat, on a table or counter top, stool, swivel chair, folding chair,
unstable chair or any chair where the straps cannot secure it properly.
· Minimum dimensions of adult chair that the booster seat shall be attached to: Seat width 18 in. and
depth 18 in., and the seat backrest height is at least 8 in. tall.
· Until child is able to get in and out of the booster seat without help (about 2½ years old), the child should be
secured in the booster seat at all times by the restraining system. The tray is not designed to hold the child in
the chair.
•Use this product only with children capable of sitting upright unassisted.
· Check that both the floor and seat of the chair are level before installing the booster seat.
· Prevent finger injury: Keep child away from chair when installing the tray.
· Once installed, check the security and position of the booster seat.
· Do not use this booster unless all components are correctly fitted and adjusted.
· Discontinue use of the product if damaged, broken, or disassembled.
PREVENT FALLS: ALWAYS USE ADULT CHAIR STRAPS
when using product on elevated surfaces as a booster
seat.
Infant Floor/Support Seat Use:
Booster Seat Use:
WARNING

D
E
F
AFabric Seat
B
E
Backrest
Feeding Tray
D
FAdult Chair Straps (4)
GLong Screws (2)
components:
assembly:
1
3
Hardware:
!
Seat Base will come preassembled
with: Fabric Seat and Restraint Straps
x2
G
Restraint Strap
Seat Base
C
Replacement parts:
13630-02 : Fabric Seat
13630-06 : Tray
13630-13 : Waist Restraint
(Chair straps and T-buckle)
B
A
C
Move seat pad to
center of seating
area.
Firmly push down on backrest to
lock it into the base.
NOTE: Ensure backrest and base
are fully connected. Test
connection points before use.
Insert backrest
into slots on both
sides of seat.
2
3
click!
click!
click!
click!
click!

assembly (continued):
x 2
4
4
Flip the seat over.
Insert and fasten
the 2 long screws.
G
x 2
Helpful Hint: If possible, use a long screwdriver on
the two screw locations.
!
Note: Bottom front T-straps will be
attached prior to rst use. To re-attach
fabric seat if you need to remove and
machine wash it, rethread T-straps through
the slots.
!

assembly (continued):
5
Thread the three
T-straps on the back of the
fabric seat into the slots on
the backrest.
5
6
Insert the four plastic fasteners
into the keyhole slots on the front of the
seat frame. Slide fasteners to lock.
x 2
Insert the two plastic fasteners
on the underside of the
fabric seat into the
top of the seat frame.
x 2
7
x 3
Note: Pull up to ensure the straps are fully
inserted. They should not pull out of the slots.
!
x 2

assembly (continued):
click!
Note: It may help to
place one hand on the
back of the activity tray.
Pull on all sides of the
tray to ensure that it is
fully connected.
click!
!
8
6
Connect tray to the seat as
shown.
The tray is not designed to hold the child in
the chair. ALWAYS secure child in the restraint.
WARNING

modes of use:
7
Positioner/Support Seat Feeding Seat
Use on the oor or on an adult chair
(chair straps included).
Booster Seat
Use on an adult chair (chair straps included).
Fabric insert supports baby’s waist & back. Use
for babies just learning to sit up unassisted.
3
21 Only use for children who are able to
hold their head up unassisted
(approximately 4 months of age).
Stop using as a Posi�oner/Support Seat
when child can walk or get in and out of
product by themselves (approximately
12 months of age).
!
Only use for children who
can sit up unassisted.
!
WARNING
When seat is used on an adult chair,
use only the feeding tray.
!
Only use for
children who can
sit up unassisted.

child restraint:
8
remove tray:
ALWAYS secure child in the restraint.
WARNING
Pull the lever beneath the
feeding tray.

attach to adult chair:
be sure to
tighten straps!
press in
to release
Never use on an adult chair without securely
fastening chair straps. Always tighten adult
chair straps and test security before use.
IMPORTANT
9
x 4
F
1
2
Note: Pull up to ensure the straps
are fully inserted. They should not
pull out of the slots.
!
Thread the adult chair
straps (F) into the slots
on the underside of the
seat base.
Fasten clips
around the chair
back and under-
neath chair seat.

storing adult chair straps:
10
Once fully assembled,
a storage pocket is located
underneath the front of the seat.
This pocket is used to store
the adult chair straps.
Coil straps and insert.

removing fabric seat:
11
x 3
x 2 x 2
1
4
32
x 2
Remove the feeding tray.
Pull up the
two fasteners
on the underside
of the fabric seat
by lifting them up
and out from the
seat base.
Remove the
four fasteners
from the keyhole
slots on the front
of the seat base
by sliding out.
Remove the
three T-straps from the
slots on the backrest.

Colors and styles may vary.
MADE IN CHINA.
4/19
Summer Infant (USA), Inc.
Summer Infant stands behind all of its products. If you
are not completely satisfied or have any questions,
please contact our Consumer Relations Team at
401-671-6551 or www.summerinfant.com/contact
removing fabric seat (continued):
cleaning & maintenance:
• Fabric Seat: Machine wash, cold water, gentle cycle, no bleach. Tumble dry, low heat.
• Wipe frame with a damp cloth and mild soap.
• Do not use if any components are damaged missing, broken, or disassembled.
5 6
x 2
1275 Park East Drive
Woonsocket, RI 02895 USA
401-671-6551
© 2019 Summer Infant, Inc.
Remove the
two T-straps from the
slots underneath
the seat. Remove
fabric seat
from restraint
straps.