Summer 13500 User manual

13500
• PREVENT FALLS:
• Never use near stairs. Never use on any elevated surface.
• To avoid tip over, place product on a flat level surface.
• Strings can cause strangulation! DO NOT place items with a string around child's neck, such
as hood strings or pacifier cords. DO NOT suspend strings over product or attach strings to toys.
CAUTION: KEEP SMALL PARTS OUT OF CHILD'S REACH.
WARNING:
Never leave child unattended.
Always keep child in view while in product.
• Always secure child using restraint straps until child is able to get in and out of the booster seat
without help (about 2 1/2 years old).
• Never leave child unattended.
• Do not use in motor vehicles.
• ALWAYS secure BOTH back and seat straps to an adult chair.
• NEVER allow child to push away from table.
• NEVER lift this product with your child in it.
• NEVER use soft seat without main seat.
• Do not use this product if it is damaged or broken.
• ALWAYS remove tray sections for proper fit to an adult chair during booster seat usage.
• Use ONLY for a child that can sit up unassisted.
• NEVER use this product as a car seat or bath seat, on a table or counter top, stool, swivel chair, or
any other chair where the straps cannot secure it properly.
• For use on a chair whose seat dimensions are greater than those of the booster seat.
• Check that both the floor and seat of the chair are level before installing the booster seat.
• Once installed, check the security and position of the booster seat.
• Always check security of fit to adult chair before each use.
• Do not use on a stool, an unstable chair or folding chair.
• Do not use this booster unless all components are correctly fitted and adjusted.
• Be aware of the risk of open fire and other sources of strong heat, such as electric bar fires, gas
fires etc. in the vicinity of the booster seat.
• NEVER use the toybar to lift or carry product with infant in it.
WARNING:
Prevent serious injury or death from sliding out, falls,
or tipping over.
Please read the following instructions and
warnings carefully before use.
Keep this instruction manual
for future reference.
For technical support see page 4.
For use with children from 4 months to 4 years.
Maximum weight 33 lbs. (15 kg.)
Adult Assembly Required.
4
Please check the following before each use:
Make sure the screws that hold the tray together are tight and that none are
missing. Make sure toys are fully engaged to the tray at all times.
Wipe plastic components with warm soapy water and rinse clean. Wipe with a clean dry cloth.
To clean toy bar, wipe with damp cloth and mild soap. Air dry. Do not immerse in water.
TO CLEAN:
MAINTENANCE:
Summer Infant, Inc.
1275 Park East Drive
Woonsocket, RI 02895 USA
1-800-268-6237
© 2016 Summer Infant, Inc.
Colors and styles may vary.
Please retain information for
future reference.
ASSEMBLED IN USA OF US AND
IMPORTED COMPONENTS. 8/16
INSTRUCTION MANUAL
3-STAGE DELUXE SUPER SEAT®
M
Rear
chair
strap
Side chair strap
K
Summer Infant stands behind all of its products. If you
are not completely satisfied or have any questions,
please contact our Consumer Relations Team at
1-800-268-6237 or www.summerinfant.com/contact
connect with us:
Stage 3: Booster seat
NOTE: All straps must be used during booster seat mode.
Step 1: Remove entire tray from unit.
Step 2: Locate chair straps taped to the bottom of the seat base.
Step 3: Flip seat unit over. Slide folded ends of chair straps into
slots on the back of the seat. Pull up to ensure chair straps are
secured in slots. Repeat for slots in the side of seat with the
second set of chair straps.
Step 4: Place booster seat onto chair. Pass the bottom chair straps
under base of chair and secure buckle. Pull and tighten chair strap
to ensure a snug fit (Figure K).
Step 5: Pass rear chair strap around back of chair and secure
buckle. Pull and tighten chair strap to ensure a tight fit (Figure L).
Step 6: Unbuckle child restraint straps and place child in seat.
Buckle child into child restraint and tighten straps for a snug
and secure fit (Figure M).
SET-UP & USE (continued):
L

Step 2: Using Phillips Head screwdriver, screw
rear tray section into right-side tray section
with 2 screws (Figure B).
Step 3: Using Phillips Head screwdriver, screw
rear tray section into left-side tray section with
2 screws (Figure C).
Step 4: Turn tray over, insert toy bar mounts into corresponding receptacles
with spinners facing inward as shown (Figure D).
Step 5: Insert other 2 toys into locations shown (Figure E).
Step 6: Slide 3 piece tray section exactly as shown
in Figures F & G until engaged in seat track.
Step 7: Rotate 3 piece section clockwise until
opening in tray matches the opening in seat.
Step 8: Slide front tray section onto activity tray by squeezing and releasing
front latch to lock into place (Figure H).
Step 9: Insert both sides of the toy bar into toy bar mounts as shown
in Figure I.
Step 10: Attach fabric toys through the loops in the toybar and secure them
with “hook and loop” fasteners. (Figure J) .
Step 11: Unbuckle child restraint straps and place child in seat. Buckle child
into child restraint and tighten straps for a snug and secure fit.
NOTE: When placing baby in and out of seat, rotate tray so
that front tray section is in front of the child.
D
E
2
Activity tray
(4 sections)
COMPONENTS:
Stage 1: Infant support seat
(no assembly necessary)
Step 1: Unbuckle child restraint straps and place child in seat.
Buckle child into child restraint and tighten straps for a snug
and secure fit.
NOTE: For larger babies, soft seat can be removed
by pulling straps through slots in soft seat.
Stage 2: Floor time activity seat
Step 1: Take the 4 tray sections and lay out each piece,
underside up (Figure A).
SET-UP & USE:
QUICK GUIDE:
Stage 1:
infant support seat
(with or without soft seat)
Use when child can hold up
head unassisted.
Stage 2:
floor time activity seat
(with or without soft seat)
Use until child begins to
walk unassisted.
Stage 3:
booster seat for toddler
(with or without soft seat)
A
rear
front
left right
C
B
screws screws
3
SET-UP & USE (continued):
Plastic toys (4)
* Child restraint straps
are pre-assembled
on product.
** Chair straps are taped
to the underside of
the seat.
Toybar (1)
Soft toys (2)
*Colors and styles may vary.
Chair
straps** (2)
G
H
I
J
Screws (4)
Soft
seat
Main
seat
Child
restraint
straps*
Seat assembly
F
L