BPS SunPower 40WSolar Panel
- 5 -
CHARGE TIME
Charge mes will vary based on the amount of power the SunPower Solar
Panel is able to collect from the sun. In opmal condions the FreedomTM
or C-100 CPAP Baery can be quick charged to approximately 80% of its
capacity in 4-5 hours and a full charge can be obtained in approximately 8
hours when the baery is fully discharged.
OPTIMAL CHARGING CONDITIONS
direct sunlight with the solar panels angled toward the sun between
30° to 50° from the horizontal (flat) moving the panels throughout the
day to follow the movement of the sun
no clouds
no shade covering any of the solar panels
no hanging branches or other obstrucons to direct sunlight
no dirt or debris on the solar panels
SAFETY & CARE INSTRUCTIONS
While the SunPower Solar Panel is flexible, only fold the natural
creases in the all-cloth porons of the panel.
Do not fold with the solar cells facing outward. Always protect the
solar cells when not in use.
Do not aempt to charge non-rechargeable baeries or devices with
non-rechargeable baeries.
Do not machine wash, machine dry, or dry clean.
If dirt or debris collect on the solar panels use a clean, wet cloth to
wipe the panels. Do not use soap or solvents as they can create a film
on the solar panels which can affect performance.
Make sure the SunPower Solar Panel is clean and dry before storage.
- 2 -
CHARGING OTHER SMALL ELECTRONIC DEVICES
Plug the DC input cord into the connecon cord of the SunPower
Solar Panel.
Plug the DC power cord (auto charge cable) of the electronic device
into the DC input cord.
Connect your electronic device to its DC power cord.
Place the SunPower Solar Panel facing toward direct sunlight to
begin the charging process.
Make sure to read the charging instrucons for your specific device.
The SunPower Solar Panel does not have an internal charge
controller and overcharging your device may result in damage to
the device’s internal baery.
As soon as charging is complete disconnect the SunPower Solar Panel
from the electronic device.
NOTE: Some devices may not be able to accept the full 18V output of the
SunPower Solar Panel. These devices will require the use of the charge
controller in conjuncon with the DC input cord.
Plug the charge controller into the solar panel connecon cord.
Plug the DC input cord into the charge controller.
Plug the DC power cord (auto charge cable) of the electronic device
into the DC input cord.