Sunlight e-CUT SZ 0401 User manual

Dispenser Installation Guide
Dispensers

This installation guide caters to the following dispensers
e-CUT (SZ 0401) SENSOR PAPER DISPENSER ART-394 CENTREPULL DISPENSER
ART-SL810 AUTO CUT PAPER TOWEL
DISPENSER ART-396 TWIN ROLL DISPENSER
ART-512 JUMBO ROLL DISPENSER ART-SL2008 TWIN ROLL DISPENSER

You may use the 3M heavy duty / mounting tape for the
following dispensers
ART-518 INTERLEAVED DISPENSER ART-812 PAPER HAND TOWEL DISPENSER
DC 800 SOAP DISPENSER

Safety Goggles Ear Plugs Respiratory Mask
Always wear appropriate protective gear
Follow safety regulations and procedures
You will need the following tools:
4 screws & 4 wall anchors (electric) Screwdriver Tape measure
Electric drill Hammer Marker or pencil
x4
x4
or
or

How high should you mount paper dispensers?
Reach limits for soap and hand towel dispensers do not differ in locations for instance,
bathrooms, kitchens and pantry. Recommended height to install a dispenser is between 1300-
1520mm above the floor.
Following NEA regulations for amenities to be provided in public toilet, paper towel dispenser
shall be provided for every two count of wash hand basins, subject to a minimum of one.
Paper towel dispensers shall be positioned directly above and at least between every two
wash hand basins.
1300mm-1520mm 1300mm-1520mm
610mm

How high should you mount JRT dispensers?
From side view, mount within 180-220mm in front of toilet from centerline and 760-890mm
above the floor.
Centerline
760mm-890mm
180-220mm
760mm
890mm
Following BCA Regulations, from top view, mount within 350-400mm from centerline of toilet
bowl to cubicle wall.

How high should you mount JRT dispensers in
ambulant disabled toilets?
Following BCA Regulations, jumbo toilet roll dispenser is allowed provided it is reachable &
does not interfere with the use of grab bars.
• 150 mm ≤ Ht ≤ 200 mm above the horizontal grab bar
•Approximately 50 mm from the front edge of the seat to the centerline of the toilet roll
dispenser

Tools required
Measure the desired height of the
dispenser from the floor
760mm-890mm
from the floor
Step 1:
Mark your hanging points using a
marker or pencil
Step 2:

Tools required
x4
Do not make the hole wider
than the wall anchors
Drill into the hanging points using the
electric drill
Step 3:
Use a hammer to tap the wall anchors
into the wall
Step 4:

Tools required
x4
Place the dispenser on the wall and
insert the screws into the wall anchors
Step 5:
Installation complete!
Step 7:
Use a screwdriver or electric
screwdriver to tighten the screws
Step 6: