Sunnydaze Decor WAR-191 User manual

5010198
1.
OWNER'S MANUAL
Item No.: WAR-191
READ BEFORE USE!

CONSUMER: Retain this manual FOR FUTURE RE FERENCE. READ
CAREFULLY AND COMPLETELY BEFORE ASSEMBLY OR USE
●FOR USE WITH 1.02LBS CYLINDER WITH TYPE 1 CONNECTION ONLY (NOT SUPPLIED)
For propane use only.
●This outdoor gas appliance is to be installed on a flat, solid and NON COMBUSTIBLE surface.
DANGER!: If the information in this manual isnot followed exactly, a fire or
explosion may result causing property damage, personal injury or loss oflife.
DANGER
FIRE OR EXPLOSION HAZARD
If you smell gas:
1.Shut off gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, keep away from theappliance and immediately call your
gas
Failure to follow these instructions could result in fire or explosion, which
could cause property damage, personal injury,or death.
supplier or fire department.
WARNING
-Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
-An LP-cylinder not connected for use shall not be store in the vicinity of this
or any other appliance.
WARNING: For Outdoor Use Only.
Installation and service must be performed by a qualified installer,
service agency, or the gas supplier.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manval for future reference.

DANGER
WARNING
DANGER.
NEVER.
WHEN CONNECTING FOR USE:WARNING:
Know the odor of LP-gas. If you hear, see
or smell leaking LP-gas, immediately get
everyone away from the cylinder and call the
Fire Department. Do not attempt repairs.
Use only in compliance with applicable codes.
Read and follow manufacturers instructions.
Consult manufacturer’s instructions
concerning the cylinder connection provided
with your appliance.
Be sure regulator vent is not pointing up.
Turn off all valves on the appliance.
Do not check for gas leaks with a match or
open flame. Apply soapy water at areas
marked “X”. Open cylinder valve. If bubble
appears, close valve and have LP-gas
service person make needed repairs. Also,
check appliance valves and connections to
make sure they do not leak before lighting
appliance.
When appliance is not in use, keep the
cylinder valve closed.
Light appliance(s) following manufacturer’s
instructions.
Caution your LP-gas supplier to:
Be certain cylinder is purged of trapped
air prior to first filling.
Be certain not to over fill the cylinder.
Be certain cylinder requalification date is
checked.
Contact with the liquid contents of cylinder
will cause freeze burns to the skin.
Do not allow children to tamper or play with
cylinder.
Do not use, store or transport cylinder where
it would be exposed to high temperatures.
Relief valve may open allowing a large
amount of flammable gas to escape.
Do not store a spare LP cylinder under or near a barbecue grill,or other heat sourced.
Fill an LP cylinder beyond 80% full: a fire causing death or serious injury may occur.
LP-gas is heavier than air and may settle in
low places while dissipating.
FLAMMABLE GAS UNDER PRESSURE.
LEAKING LP-GAS MAY CAUSE A FIRE OR EXPLOSION IF IGNITED
CAUSING SERIOUS BODILY INJURY OR DEATH.
CONTACT LP GAS SUPPLIER FOR REPAIRS, OR DISPOSAL OF THIS
CYLINDER OR UNUSED LP-GAS.
FOR OUTDOOR USE ONLY.*
DO NOT USE OR STORE CYLINDER IN A BUILDING,
GARAGE OR ENCLOSED AREA.
DO NOT REMOVE, OEFACE, OR OBLITERATE THIS LABEL
EXCEPT AS AUTHORIZED BY ANSI / NFPA 58.
When not connected for use, keep cylinder
valve turned off. Self contained appliances
shall be limited to a cylinder of 1 lb
capacity or less.
When transporting, keep cylinder secured in
an upright position with cylinder valve turned
off.
Pressure relief valve
Cylinder
Liquid level indicator
(optional)
Point of connection
M
M
M
M
M
Cylinder valve hand wheel
3.

TABLE OF CONTENTS
Important Safety Information.………………………………………………….…… page 5
Information About Propane (LP) Gas………………………………………………page 6
Specifications..…………….………………………………………………………….page 6
Product Diagram…..………………………………………………………….…… page 7
Installation Instructions…………..……………………………………..….……….. page 8
Operation Instruction……………..……………………………..…………………... page 10
Maintenance Information..…………………………………………………………... page 10
Parts List...........................…………………………………………………………... page 11
Installation Instructions…………..……………………………………..….……….. page 9
4.

IMPORTANT SAFETY INFORMATION
•The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code
ANSI Z223.1/NFPA 54 or CAN/CGA-B149.2 Propane Installation Code.
•Use as directed – do not modify. Do not operate unit when wet.
•The appliance area must be kept clear and free from COMBUSTIBLE materials, gasoline, and other flammable vapors
and liquids.
•To clean burner and fireplace body, use a soft brush after the burner has cooled completely. Never use a vacuum
cleaner for the burner.
•Do not use this appliance if any part of the burning system has been under water. Immediately call a qualified service
technician to inspect the appliance, and to replace any part of the control system and any gas control which has been
under water.
•Before each use of this gas appliance, the burner must be inspected against any deformation and break. The burner for
this appliance is not replaceable.
How to perform a gas leak test: Prepare some soapy water in a spray bottle before making this test. Make sure you
are in a very well-ventilated area OUTDOOR!
Connect gas canister and open the gas inlet valve.
Spray abundantly over the gas connections. Do not spray the burner.
If you can see bubbles, stop, shut off the inlet valve and verify the connections are tight including the canister.
Repeat the test. If the bubbles still persist, do not attempt to light the burner.
Shut off all gas and seek professional help.
•Never use a flame to check for gas leaks. A statement that solid fuels shall not be burned in this appliance; the
minimum inlet gas supply pressure for the purpose of input adjustment.
•Children and adults should be alerted to the hazards of high surface temperatures and keep a safe distance to avoid
burns or clothing ignition.
•Young children should be carefully supervised when they are anywhere near the appliance.
•Clothing or other flammable material should not be hung from the appliance, or place on or near the appliance.
•Any guard, barrier, or other protective device should be removed for servicing the appliance shall be replaced prior
to operating the appliance.
•For appliances requiring a barrier, as determined under Clause 5.20.2, A barrier designed to reduce the risk of burns
from the hot viewing glass is provided with this appliance and shall be installed for the protection of children and
other at-risk individuals.
•If the barrier becomes damaged, the barrier shall be replaced with the manufacturer’s barrier for this appliance.
•Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system and any gas control that has been under water.
•When the appliance is equipped with a CGA No. 600 Cylinder Connection, a statement that specifies that the cylinder
be disconnected when the appliance is not in use.
•A list of replacement parts and the source where such parts are available.
•A pictorial diagram in at least two views or a single exploded view depicting proper positioning of field assembled
parts. The following statement must be included with the pictorial diagrams: “Failure to position the arts in
accordance with these diagrams or failure to use only parts specifically approved with this appliance may result in
property damage or personal injury.”

INFORMATION ABOUT PROPANE (LP) GAS
A self contained LP-gas for use with this appliance must have a capacity of 1.02 lbs. (height 8 inch, 200mm;
diameter 4 inch, 100mm).
The LP-gas supply cylinder to be used must be constructed and marked in accordance with the specifications for
LP-gas cylinders of U.S. Department of Transportation (DOT) or the National Standard of Canada,
CAN/CSA-B339
●This appliance shall be used only outdoors in a well-ventilated space and shall not be used in a
building, garage or any other enclosed space.
●The propane gas pressure regulator with this appliance must be used. If they do not work, contact the
service center toll free for replacement. .
●Storage of this appliance indoors is permissible only if the cylinder is disconnect and removed from the
appliance.
●Cylinders must be stored outdoors out of the reach of children. Disconnected cylinders must have
threaded valve plugs tightly installed and must not be stored in a building, garage or any other
enclosed areas.
, Outdoor
SPECIFICATIONS
Canadian Standards Association certified to “ANSI Z21.97-201 / A
Gas Fireplace”
INPUT: 8000 Btu/hr High Fire
Propane Regulator Pressure: 11 inches water column
minimum inlet gas supply presure:10psi
Maximum Inlet Gas Supply Pressure: 250 psi
Clearances to combustible surfaces: Sides 24" Top 48"

1
2
3
4
5
6
7
8
9
10
No. No.PARTS NAME METERIAL
1BODY
2BURNER
3M4.0*6.0
4 GASKET SEAL
5BURNER CONNECTIN
6RETULATOR ASS’Y
7M6.0*25.0BOLT
8
BURNER SOLEPLATE
9
KNOB
10
1
1
3
1
1
1
4
1
1
1
PART
SUS430
Q235
PART
SUS430
PART
Q235
SUS430
ABS
BEG
FIRE GLASS

INSTALLATION INSTRUCTIONS
WARNING:
This item is heavy. All necessary
precautions should be taken when lifting
and assembling this fireplace.
Make certain the fireplace body always
remains upright. Do not lie on its side or
you could cause damage to the body.
Most parts of this fireplace are pre-assembled
before shipment. Please follow below assembly
instructions before you start to enjoy your
fireplace.
Step 1: Carefully unpack the product, and take
out all the components. Make sure you take out
all the packaging materials as well.
Step 2: Put the fireplace body on the final
position. It should only be put on a flat and
NON-COMBUSTIBLE floor, and there must be a
minimum of 24 inches of clearance from the
tabletop to COMBUSTIBLE walls. Make sure the
valve on the control panel is turned all the way
clockwise to the “OFF” position. (Figure 1)
Step 3: Put up the body (Figure 2), put up 1
pound gas tank’s adopter to connect valve
assembly tight it up by clockwise direction.
(Figure 3)
Step 4: Put the lava rocks around the burner.
Make sure the height of lava rocks don’t be over
the rim of top(Figure 4)
Now you’re ready to enjoy your pillar fireplace.
Follow the operation instructions when you’re
using this appliance
(Figure 1)
(Figure 2)
(Figure 3)
(Figure 4)

Parts List/Assembly Table
INSTALLATION INSTRUCTIONS
1. Put the basin stand on a clean level surface that cannot be damaged by
water.
2. Put the pump in the fountain basin, thread the electric cord through the
pipe that is not in the center down into the center of the stand.
3. Put the upper fountain on its edge (as shown).
4. Connect the hose to the pump.
5. Put the upper fountain in place make sure it fits all the way down. Do not
force wiggle and push gently down until it sits on the bottom.
6. Put the pump cover in place.
7. Connect a 1lb propane tank to the metal connection inside the column.
8. Fill the clean water.
9. Put the proper tank cover in place.
10. Start as per operating instruction (following page).
11. Plug pump outlet into a properly grounded outlet, check the water flow.

OPERATION INSTRUCTIONS
Lighting and Setting Control for Gas
Before lighting, make sure the valve knob is in the “OFF” position.
1. From the OFF position, push in and turn control knob counter-clockwise to the
LOW position.
2. Always perform a leak test before lighting the burner. See page 4
3. Hold a lit match within ¼” to the lava logs as shown on below picture, until the
burner is lit. If burner fails to light, turn to OFF. Wait 5 minutes before attempting
to re-light.
4. Turn control knob to desired heat setting, LOW or HIGH.
Shut-down for Gas
1. Turn the control knob gently to “OFF” position.
2. Disconnect and remove the gas tank when the gas fireplace is not in use.
MAINTENANCE INFORMATION
1. Adjust the control knob to reach different height for flame.
2. If in raining day, burner should be turned off, and put the cover on the burner.
Vinyl cover should not be put on this fireplace until the fireplace is cooled down.
Do not light or use gas unit if lava rocks are wet, ensure lava rocks are
completely dry before igniting as intense heat could cause the rock to crack.
3. It is recommended that the fireplace be stored indoors in freezing temperatures.
The cylinder must be disconnected and removed from the appliance before the
appliance can be stored indoors.
4. The propane canister must be stored outdoors and never close to the operating
unit.