SUNVILLA Bellafina Quickspecs

If you have any questions or any missing parts pertaining to the assembly of this product, before
returning if to your retailer, please contact our customer service department at 1-888-690-9800 or
email [email protected], 5:00 a.m. - 5:00 p.m. PST / 8:00 a.m. - 8:00 p.m. EST,
Monday - Friday.
Made in China
PREPARATION
Before beginning assembly of this product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any parts are missing or damaged, do not
attempt to assemble this product. Stop and call our customer service center at 1-888-690-9800.
INFORMATIONSAFETY
ASSEMBLY / CARE & USE INSTRUCTIONS
IMPORTANT, RETAIN FOR FUTURE REFERENCE:
READ CAREFULLY
Round Dining Table
Bellafina 5 Piece Dining Set
Please read and understand this entire manual before attempting to assemble or install the product.
This outdoor furniture is designed and made for personal non-commercial use. It should not be
used as a toy or tool. Children should not engage in the assembly, removal, or disassembly of the
product.
Page 1 of 3

1
1
3fo2egaP
Item#: FWA10128
Table Leg
B
Table Leg Connector
Table Top
Parts & Tools
4
8
8
Ø13*Ø6.5*1.0 Flat Washer
M6*25
Bolt
Wrench
BB
Part List Hardware List
AAA
CC
DD
C
4
M6*40
Bolt
8
D
E
1
1
Table Cap
Table Ring
Aluminium Wicker Round Dining Table
WARNING: To avoid damage of your
new patio furniture, please use either
the carton or another soft surface such
as carpet as a working surface to prev-
ent product damage during assembly.
EE 1
Flat Washer

Step 1:
Step 2:
Step 3:
Line up the bolt holes on the table leg connector (B) with the
corresponding bolt holes on the table legs (A).
Screw the M6*40 bolts (CC) with flat washers (AA) using the wrench (EE).
Page 3 of 3
Line up the bolt holes on the table legs (A) with the
corresponding bolt holes on the table top (C).
Screw the M6*25 bolts (DD) with flat washers (BB)
using the wrench (EE).
(* Reminder - Do not completely tighten the bolts now.)
With a second person’s assistance, return the table to
the upright position and onto a flat level surface.
Put the table ring (E) into the umbrella hole, then
cover with the table cap (D).
(* Reminder - The foot cap can be adjusted as shown.)
Repeat this step until the table connector (B) is connected
to the table legs (A). Now tighten all the bolts as shown.