SUNVILLA Lago Brisa 7 Piece Dining Set Quickspecs

Lago Brisa 7 Piece Dining Set
Rectangular Dining Table
ASSEMBLY / CARE & USE INSTRUCTIONS
IMPORTANT, RETAIN FOR FUTURE REFERENCE:
READ CAREFULLY
If you have any questions or any missing parts pertaining to the assembly of this product, before
returning if to your retailer, please contact our customer service department at 1-888-690-9800 or
email [email protected], 5:00 a.m. - 5:00 p.m. PST / 8:00 a.m. - 8:00 p.m. EST,
Monday - Friday.
PREPARATION
Before beginning assembly of this product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any parts are missing or damaged, do not
attempt to assemble this product. Stop and call our customer service center at 1-888-690-9800.
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble or install the product.
This outdoor furniture is designed and made for personal non-commercial use. It should not be
used as a toy or tool. Children should not engage in the assembly, removal, or disassembly of the
product.
Made in China
Page 1 of 3

Parts & Tools
Aluminium Wicker Rectangular Table
Item#: FWA19973
Part List
A1
Table Top
B2
Table Leg
C2
Table Leg
D1
Table Leg Connector
E1
Table Cap
F1
Table Ring
Hardware List
AA 4
Ø13*Ø6.5*1.0 Flat Washer
BB 4
M6*15 Bolt
CC 8
Ø16*Ø8.5*1.0 Flat Washer
DD 8
Spring Washer
EE 8
M8*40 Bolt
FF 1
Wrench
WARNING: To avoid damage of your
new patio furniture, please use either
the carton or another soft surface such
as carpet as a working surface to prev-
ent product damage during assembly.
Page 2 of 3

Step 1:
Line up the bolt holes on the table leg connector (D) with the
correspondin g bolt holes on the table legs (B) and the table legs
(C). Screw the M6*15 bolts (BB) with flat washers (AA)
using the wrench (FF).
(* Reminder - Do not completely tighten the bolts now.)
Step 2:
Line up the bolt holes on the table legs (B, C) with
the corresponding bolt holes on the table top (A).
Screw the M8*40 bolts (EE) with flat washers (CC)
and spring washers (DD) using the wrench (FF).
Repeat this step until all table legs (B,C) are connected to
the table top (A). Now tighten all the bolts as shown.
Step 3:
With a second person’s assistance, return the table to
the upright position and onto a flat level surface.
Put the table ring (F) into the umbrella hole,
then cover with the table cap (E).
(* Reminder - The foot cap can be adjusted as shown.)
Page 3 of 3