Superior Planter Box User manual

SPPIG180928
• These directions are only a guide and may not address every situation.
• Always wear proper safety equipment while assembling and installing.
• The installer should obtain all required building permits and follow all installation procedures in accordance
with applicable building code requirements.
• Superior Plastic Products, Inc. shall not be held liable for improper or unsafe installations.
• Applying paint, will void your warranty.
• To ensure proper coverage by our warranty please visit our website and complete the warranty form and mail
to: Superior Plastic Products, Inc., 260 Jalyn Drive, New Holland, PA 17557
Addtl. Components 14" x 24"
• (6) 9" Wall Panels
• (4) 13’’ Side Rails w/ channels
• (2) 23’’ Side Rails w/ channels
Addtl. Components 14" x 34"
• (8) 9" Wall Panels
• (4) 13’’ Side Rails w/ channels
• (2) 33’’ Side Rails w/ channels
SuperiorPlasticProducts.com
Planter Box
14" x 14", 14" x 24", 14'' x 34''
What's Included 14" x 14"
• (4) 1-3/4"sq. x 17" Posts
• (1) Floor Section (pre-assembled)
• (4) 9" Wall Panels
• (6) 13’’ Side Rails w/ channels
• (16) Screws, Washers, and Caps
WARNING: This product can expose you to chemicals including Quartz (crystalline silica), which is known to the
State of California to cause cancer, and Hexavalent Chromium, which is known to the State of California to cause
birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

SuperiorPlasticProducts.com
260 Jalyn Drive ● New Holland, PA 17557
Ensure a tight t, and secure using
provided Screws at each corner
position (see example: circled)
Then Place the Panels into the open
Channels.
Place Posts onto the short side Rails
which contain (2) Side Channels.
Note: Attach washer
before fastening screw,
then attach cap.
Continue by placing this group onto
the Floor Section.
Now, place the Rails with (1) Channel
onto the Panels, and into the routed
Post holes.
2
1
34
5