Swegway Classic 6" Specification sheet

Quick Setup and
Troubleshooting Guide
For use with: all Classic 6”, Bluetooth
6” and Bluetooth 8’ boards.

Thank you for purchasing from iSwegway.com.
All of our boards are ready to use out the box.
This guide will help you quickly get started.
Please follow the steps carefully in order to
ensure you get the most out of your iSwegway.
C
O
N
G
R
A
T
U
L
A
T
I
O
N
S

Note: all of our boards come with UK CE 3 pin
chargers. We do not supply non-UK chargers.
Before we post any Swegway boards we test each
one to ensure they are in working condition.
All of our Swegway boards undergo testing in clean,
dust free designated spaces and are wiped down
and packaged carefully for our customers.
We also check and test the charger to ensure it
is fully operational.
IN YOUR BOX YOU SHOULD HAVE:
Your iSwegway board
UK CE 3 pin charger (BSI 1363 approved)
User manual
Remote (if applicable)
Protective rubber strips (If applicable, adhesive sold separately)
1
2
3
4
5

Charge for 2 hours before riding
Set your board on flat ground before riding
Get on one foot at a time
Get off one foot at a time
Be patient and calm
Wear protective clothing
Ride in a safe place free from hazards
Stop completely before getting off
Ride on level ground
Be aware of surroundings
Jump on the board
Jump off the board
Ride through water
Tow your board
Remove the casing (warranty void)
Ride at high speeds for long periods of time
Do not leave charger running for prolonged period of time or overnight
THINGS YOU SHOULD DO
THINGS YOU SHOULD NOT DO

Bluetooth functionality
(applicable to Bluetooth model boards only)
After switching on your iSwegway. You
will hear a confirmation sound indicating
the Bluetooth is ready.
Have your Bluetooth device ready; let’s say you
are trying to connect the Bluetooth on your
phone to the iSwegway. Check your phone has
Bluetooth switched on. Use your phone to
search for new devices and the iSwegway
should appear as “F008” or similar.
Once it has recognised and connected the
iSwegway will appear connected on your Bluetooth device.
Now select the music you want to listen to and you are connected.

So you are now ready to get moving!
Get on one foot at a time from behind your iSwegway board and always get off the
rear one foot at a time. First of all use the iSwegway board using just one foot i.e.
one foot on board and one on the ground. Just to feel the movement of the board.
Tip foot forward and feel the board move forward. Tip foot backwards and feel the
board move backwards. Master the board moving back and forth before trying both
feet. The iSwegway board is incredibly sensitive, slight movements are all that is
needed for the board to react.
GETTING STARTED
Quick..on the go steps...

Hold on to something i.e. to a person or a fixed object perhaps try holding
on to a kitchen work surface. Once on with both feet, stand still and allow
your board to
Balance before you move. The secret to your success is to make sure you
can stand still on your board.
Now lean slightly forward and press lightly on the front of the pedals and
you willstart to move forward. Drop your heels and therefore the opposite
applies you will move backwards. Just try to move forward and backward
while holding on.
To rotate on the board press one pedal forward and one backwards whilst
taking care to stay balanced on the. Try moving forward slowly now. Keep
holding on to someone’s hand till your confidence grows. With a bit of
patience and practice you will master it in no time. Most people can start
moving with confidence in under an hour, some people pick it up in just 5
minutes.
First time on a SWEGWAY BOARD?

The battery in your board is Samsung or LG lithium-ion and
is of the highest quality available. When you order your
board we will state whether it is fitted with a Samsung or LG battery.
When new, it may take up to twenty re-charge cycles for it to reach its
full capacity, we recommend using and recharging fully each time,
do not leave charging overnight.
If your board feels un-even or un-balanced try these steps to re-calibrate it
How do I reset or rebalance my board?
Your board from time to time may need a reset, this is easy to do:
1. Charge the board for two hours.
(The charger has a red light on it, which illuminates when plugged in, this red
lightwill turn to green when fully charged.)
1a. Then unplug the charger.
2. Turn off the board and make sure the tops of both sides of the are level. If it
is working fine both lights should be green on the top and your board should
work. If just one green light it needs rebalancing.
BATTERY
RECALIBRATION GUIDE

3. Turn off the board.
4. Hold down the “on” button for 30 seconds. The lights should come on
the board and start flashing. Let them continue for 30 seconds.
5. Turn off the board.
6. Turn it back on again two green lights on the top? All done!
How do I use the Keyfob?
The remote control is the key fob in the box. Although this has four buttons
it’s used for just turning the board on and off to save you having to bend
down. Alternatively, if you prefer you can use the silver on/off button on the
side of the. board. The other buttons are redundant and have no
functionality. Some boards come with a locking feature which allows you to
remotely lock the board so it is not able to be ridden.