SWF MAS-12 User manual

Stand Assembly Guide
SWF MAS-12 Embroidery Machine
MME-211125_VER 3.0
MOBASE SUNSTAR CO., LTD.

No. Item Q’ty Figure
1Stand Leg
(Left / Right)
2
2Caster &
Cover
4
4
3Stand Stud 4
4Bottom Bracket
(Connecting Plate)
1
5Back Bracket
(Connecting Plate)
1
1
1. Parts List (Preparation)
Upper part
of the leg
Lower part
of the leg

No. Item Q’ty Figure
6Work Shelf 2
7
Package of Nuts,
Bolts, and Screws -
7-1 Big Bolt &
Washer
12
7-2 Small Bolt &Nut 8
7-3
Screw
(For attaching the
table to the stand)
4
2
1. Parts List (Preparation)

2. Stand Assembly
3
1) Stand Left Leg / Right Leg Assembly
①Insert the upper part of the leg
into the lower part of the leg and assemble
them as shown using 4 big bolts and washers
as shown in the picture.
②After adjusting the height of the leg to a
comfortable position, tighten the 4 big bolts
firmly.
◇Big Bolts, Washers

4
①Assemble each of 4 Casters and Studs at
the bottom of the stand as shown in the
picture.
Note : Pay attention to the insertion
direction when inserting the stand cover
②Insert the 4 stand covers at the front and
back of each leg.
2) Assembling the left and right Legs with Casters, Studs, Covers
2. Stand Assembly

5
①Stand up the left and right legs together as
shown in the picture to assemble the Back
Bracket (Connecting Plate).
②Place the Back Bracket on the stand (left)
(right) and tighten it firmly using 4 big bolts and
washers each.
◇Big Bolts, Washers, Back Bracket
①With the casters of the stand facing
upward as shown in the picture, then place
the Bottom Bracket on the legs.
②Tighten the Bottom Bracket firmly using
two big bolts and washers each.
4) Assembling the Bottom Bracket
3) Assembling the Back Bracket
◇Big Bolts, Washers, Bottom Bracket
2. Stand Assembly

6
①Align the assembly holes for the
four corners of the Work Shelves as
shown in the below photo.
5) Assembling the Top and Bottom Shelves
②Assemble the top and bottom Work Shelves using 4 small bolts & nuts.
The method of assembling the upper and lower work shelves is the same.
(Note: Assemble so that the folded part of the plate faces backward as shown below)
Note: Folded part (L-shape)
Top
Bottom
2. Stand Assembly

7
◇Front ◇Back
Place the table on the stand and fix the
table using 4 table fixing screws.
6) Assembled Stand
Caution : Turn the table and stand over to fix
the screws easily, and then tighten the screws
as shown in the picture below)
7) Attaching the Table to the assembled Stand
- The end -
3. Table Assembly