• Enter 2.4GHz Wi-Fi credentials, click continue
• Choose room, name device (e.g., ERV or Bathroom Fan), click continue
• Enable Air Exchanger Mode, select an Air Quality level below which the Auxiliary Control
Switch + Air Quality Sensor will turn on your Energy Recovery Ventilator or Fan.
• Modify settings: long press the Switch in Rooms view > Device Settings > Device Modes
or navigate to Automations > '+' > Device Modes
Setting Up 15A Outlet + Air Quality Sensor
• Insert Air Quality Sensor into 15A Outlet, wait for power up, and ensure it is blinking
green
• Ready to pair with Swidget app; 5-minute Discovery Mode
• Restart Discovery Mode by removing and reinserting Insert
• Click '+' to add device, choose Bluetooth Pairing, select 15A Outlet + Air Quality Sensor
• Enter 2.4GHz Wi-Fi credentials, click continue
• Choose room, name device (e.g., Living Room Outlet), click continue
• Enable IAQ Participant Mode, select an Air Quality level below which the 15A Outlet +
Air Quality Sensor will remotely turn on your Energy Recover Ventilator
Troubleshooting
No Power To The Device
Potential Issue(S):
• The wiring device is not controlling the circuit or providing power.
• The Insert has been properly installed into the Wiring Device but its indicator LED is OFF.
Possible Solutions:
• Verify if the circuit breaker has been turned ON.
• Verify the wiring to the switch or outlet.
Wi-Fi Connection Problems
Potential Issue(S):
The Swidget app is failing to connect the insert to the Wi-Fi network,
8Indoor Air Quality
