Syma K-16 User manual

Battery safety information

Using the vehicle

Thank you for purchasing one of ourtoy products. To ensure that you get the most out of your

new purchase, please read these instructions carefully before using the toy for the first time.

They contain important information on how to operate the product.

Inserting the remote control batteries

Remote control

Check the ON/OFF switch is in the “OFF”

position.

Use a screwdriver to loosen the screw.

3.Remove the battery cover.

Pleaserecharge with the dedicated USB delivered by the original

factory. Never use broken USB or USB of other brands.

Please do not overcharge the battery. When the battery is fully

recharged, please pull out the charger.

Please do not recharge on the surface of the objects near

inflammable things(carpet, wood floor,solid wood furniture, etc.)

or ofconductive things. While recharging, please keep the battery

within the range of visibility.

1.The batteries must only be charged under adultsupervision.

2. Before charging the batteries, remove the battery compartment from the vehicle chassis.

3.Remove empty batteries from the vehicle and remotecontrol.

4.Ensure that the vehicle is switched off before inserting the batteries.

5.Install the battery according to the instruction inside the battery box. Make sure not toconfuse the

positive and negative polarity of the battery.

6. Donotattempttocharge non-rechargeable batteries.

7.Do not short circuit the battery terminals.

8.If you do not plan to use the vehicle for an extended period, remove the batteries from the vehicle and

remote control to prevent leakage.

9. Donot throw batteries into open flames, as this may cause them to explode or leak.

10.Do not mix old and new batteries or batteries from different manufacturers.

11.Only use batteries from recommended or reputable manufacturers.

12.Regularly inspect the batteries for signs of leakage.

13. It is suggested not to use more than 3 batteries for one single play.

14. If leaking occurs in the battery, please avoid touching the liquid with the skin and eyes.If it touches the skin,

please clean the skin with soap and clean water atonce. If it touches the eyes, please wash the eyes with

a lot of cold water at once and see the doctor right away.

15. This equipment iscomposedof electronic components and battery. The electric appliance garbage

should be given special care according to the local requirements for garbage disposal.

16. Keep this instruction manual ina safe place for future reference. It contains important information on

how to use the product safely.

·Remove the batteries when you do not plan to use the toy for an extended period.

According the polarity indicated inside in the

remote control. Put the 2*AAA battery into the

battery compartment.

Put the battery cover back and tighten

the screw.

Note: If breakdown occurs in the product, please take

out the battery for one minute, and then reinstall it. If

the breakdown still exists, please replace the battery.

The battery can only be installed by the adults.

2X1.5V“AAA”

Sketch Map of Installed Battery in the Remote Control

·Use a damp cloth to wipe the vehicle clean.

·Do not expose the toy to high temperatures, moisture or direct sunlight.

·Do not immerse the toy in water, as this may damage the electricalcomponents.

·If the wheel is too dirty or rolls inflexibly, this may influence the operation experience.

Please check it and clear up the foreign matters.

·When the wheels of remote control car is rolling, Do not touch itin order to avoid injury of

yourself or damage of the car.

·Please do not play by the road or in dangerous places in case of accidents.

·Avoid operating the vehicle in the rain or grinding the remote control vehicle over the puddle

Connect the USB charger to USB outputon computer or AC/DC adaptor,then insert the car charger plug to

the USB wire charger.(Make sure in a correct polarity)

Afull charge takes 70 minutes. When charging the LED indicator turns into red,when charging is complete,

the LED indicator stays off.

Regularly inspect the toy,battery charger, charging cable, connectors and other components for signs of

damage. In the event of any damage, discontinue use and send the parts for repair.

In case of abnormal responses such as suspicious peculiar smell, noise or smog in the charger,please

remove the power supply at once.

Indication Gravity Induction

in case of breakdown.

·Avoid operating the vehicle alongside the river, lake or pond in case the remote control or remote

control vehicle fall into the water.

·Please take out the batteries from remote control when not using.

Charging port ON/OFF

ON/OFF

Transform

Demo 1

lamp

Control bar

Demo 2

Demo 3

Mode Switching

·Demo 1：Short press on Demo 1 key for a variety offunctional demonstrations. (Different Demo keys have

different music).

·Demo 2：Short press on Demo 2 key for a variety offunctional demonstrations. (Different Demo keys have

different music).

·Demo 3：Short press on Demo 3 key for a variety offunctional demonstrations. (Different Demo keys have

different music).

·Transform：Short press Transform key , the car will transform.

·Mode Switch：Short press “Mode” key to switch the mode of car, the car will change from 360degree rotation

to left-right moving.

·Control level：Short press the control level to change the sound effect of the car, please check the operation

instruction to see more functions.

Switch on the vehicle using the ON/OFF switch.

Switch on the vehicle ON/OFF switch,make the frequency of the remote control and remote control

vehicle match each other,then you can operate the remote control vehicle.

Switch off the vehicle and remote control after use.

·The playing time is about 35 mins.

·The control rang is about 40 meters, if out of 40 meters rang , it may lose control.

Caution：

In order to avoid losing the remote control vehicle or making it lose control, follow the following steps all the time:

1.Turn on the remote control.2.Turn on the remote control car.

Turn it off according to the opposite steps.

Note: It is strictly prohibited to

put your finger on the deformed

joint when the car turn on the

switch for frequency and

deformation, so as not to hurt

your finger.

Introduce the function of the remote control and the vehicle

Caution

Charging the batteries

Care and maintenance

360°left rotation

360°right rotation

·Push the control level to the left, the car will spin

clockwise on site

Forward(Gravity induction mode)

Incline down the

remote control horizontally

·Push the control level to the right, the car will spin

anti-clockwise on site.

Backward(Gravity induction mode)

Incline up the

remote control horizontally

Keep pressing on the

Gravity Induction key

Keep pressing on the

Gravity Induction key

·Keep pressing on the Gravity Induction key,incline

down the remote control horizontally, then the car

will move forwards

360°left rotation(Gravity induction mode)

·Keep pressing on the Gravity Induction key,incline

up the remote control horizontally, then the car will

move backwards

360°right rotation(Gravity induction mode)

Incline left the remote

control horizontally

Incline right the remote

control horizontally

Keep pressing on the

Gravity Induction key

Keep pressing on the

Gravity Induction key

·Keep pressing on the Gravity Induction key,incline

left the remote control horizontally, the car will spin

clockwise on site

·Keep pressing on the Gravity Induction key, incline

right the remote control horizontally, the car will spin

anti-clockwise on site

Charging diagram of

USB charging line

Function and operation of the product

Transform

key

Press the deformation function key to make itinto off-road state ,then press again to make it into

sports car state

Forward Backward

·Push the control level forwards, the car will move

forwards

·Push the control level backwards, the car will move

backwards.

K-16 Instruction Manual of Mini Twister Car

Notes：

-This product is not suitable for children aged 6 or under. When using electrical products, precautions must be taken to preve nt the risk of an electric shock.

-Ensure adult supervision at all times

-Do not attempt to modify or re-assemble this product. Unauthorized changes may void your right to use the product.

-There are small parts in this product. The children should play it with the guard of the adults, and never swallow the small parts into their mouth.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is