Symbol LS 6004 Operating instructions

LS 6004-I0A0 Special Operating Instructions
(73-33186-0A0)
Revision A: March 1999
Special Operating
Instructions

LS 6004-I0A0 Special Operating Instructions
(73-33186-0A0)
Revision A: March 1999
2
LS 6004-I0A0 differs from the standard in the
following ways:
• Nixdorf Mode A and Mode B protocol
are supported.
• Host Serial Response Timeout parame-
ter for Standard RS-232 host in not
supported.
• The Decode Beep/LED parameter is
added.
Custom Defaults
Parameter Default
Beep/LED: Option 1
UPC-E Check Digit: No
UPC-E Preamble: None
Response Timeout: 99
Hardware Handshaking: RTS/CTS Option 3
Host Type: Beetle Mode A

LS 6004-I0A0 Special Operating Instructions
(73-33186-0A0)
Revision A: March 1999
3
Decode Beep/LED Parameter
This option allows the user to select when the
decode beep and LED occur after a good de-
code for the Nixdorf host interface. All other
host interfaces operate as in Option 1.
Option 1 The decode beep and LED occur
after a good decode.
Option 2 The decode beep and LED occur
after the data is transmitted.
Option 3 (Mode B only). The decode beep
and LED occur after the data is
transmitted and the CTS line is
made active by the host.
Scan a bar code on the next page to select the
desired option.

LS 6004-I0A0 Special Operating Instructions
(73-33186-0A0)
Revision A: March 1999
4
Decode Beep/LED Parameter
Beep/LED Option 1
Beep/LED Option 2
Beep/LED Option 3