Symbol LS1902-T Owner's manual

BARCODE SCANNER
Programming the LS1902-T & LS2208 for use with
StarShip
These instructions are for the Symbol LS1902-T & LS2208 Barcode scanner
ONLY!
The following instructions will allow the user to scan a bar-coded
Invoice\Order number into Starship and automatically “press” the Enter key.
Repetitive keystrokes such as SAVE, DEFER, REPEAT, and NEXT can
also be programmed. These repetitive keystrokes can be scanned using the
preprinted Barcodes at the end of these instructions.
You must tell the scanner what kind of keyboard connection you are using
by scanning the appropriate Barcode on the following page. Connect the
scanner to the PC and Keyboard while the PC is on (see page 1-6 of the
Online Manual for connection instructions). IMPORTANT: The keyboard
will be disabled until you scan one of the Barcodes on the next page.
The “ENTER” command must be programmed before any of the other
commands are entered. To program a command, “scan” each barcode in
order on that page. If you do not hear a beep or series of beeps, the scanner
did not read the barcode. Try scanning the barcode at different angles until
you hear the beep(s). If you make a mistake, scan the last barcode on that
page and start at the beginning of that page again. To reset the scanner back
to Factory Defaults scan this barcode:

“ENTER” Command
Scan these barcodes FIRST in order 1 through 10. If you make a mistake
just scan number 10 and start over at number 1. This command allows you to
scan an Invoice/Order number with an “Enter” command at the end.
IMPORTANT: Do not program an “Enter” command into your
Invoice\Order number Barcode.

SAVE
Scan these barcodes in order 1 through 11. If you make a mistake, scan the
last barcode and start again. The “SAVE” Barcode allows you to scan the
“SAVE” command in without using the keyboard or mouse. The “SAVE”
barcode can be found at the end of these instructions and should be posted in
a convenient place

DEFER
Scan these barcodes in order 1 through 12. If you make a mistake, scan the
last barcode and start again. The “DEFER” Barcode allows you to scan the
Defer command without using the keyboard or mouse. The “DEFER”
Barcode can be found on the last page of these instructions.

NEXT
Scan these barcodes in order 1 through 12. If you make a mistake, scan the
last barcode and start again. The “NEXT” Barcode allows you to enter
multiple packages without clicking on the Next button in Starship. The
“NEXT” Barcode can be found on the last page of these instructions.

REPEAT
13)
Scan these barcodes in order 1 through 13. If you make a mistake, scan the
last barcode and start over. The “REPEAT” barcode allows you to repeat the
package “x” amount of times (x being the number of packages) The
“REPEAT” barcode can be found on the last page of these instructions.