Symphony MOVIL 80 User manual

Owner’s Manual
DO NOT
Return to store
For help with installation or warranty issues
call
[phone] / [phone] or
www.symphony-us.com
For parts Visit our secure website
www.symphony-us.com
MOVIL 80
Please keep this important manual in a safe place. It is the owner’s responsibility to
ensure that regular maintenance is carried out on this evaporative cooling product.
Failure to do so will void all guarantees beyond statutory and legal requirements.

Symphony Cooler
Introduction
GENERAL INFORMATION
Thank you for purchasing a quality Symphony Evaporative Cooler. We care about your safety and would
ask you to spend a few minutes reading these simple instructions before installing or operating this
product.
Safety!
Read carefully all of these instructions prior to installing
and operating the unit.
•Read and Save these Instructions.
Do not throw these Instructions away.
•Complete the unit assembly before attempting to install, refer to pages 7-8.
•Installation of this cooler in any manner not prescribed by these instructions could cause a safety
issue and WILL avoid any warranty.
•Use only with a 110 - 120 V~ 60 Hz single phase grounded outlet.
•Do not operate cooler with Rear and Side Filter Panels removed.
•Do not operate cooler with a damaged cord, plug or other component.
•Do not run the power cord under carpet or other floor covering.
•Do not use the power cord with an adaptor plug that converts the 3 pin plug into a 2 prong connector.
•Do not use the cooler with an improperly grounded outlet.
•Do not alter or modify this cooler.
•Do not allow children to install, operate or service this cooler.
•WARNING: To reduce the risk of fire or electric shock, do not use this product with any solid state
speed control device.
•Use only qualified electricians for replacement or servicing of switches, or electrical motors and
components in this cooler.
•Unplug the cooler and press the Motor switch to the OFF position when installing, servicing or cleaning.
•Stagnant water may cause bacterial growth and serious health problems. Do not allow
stagnant water to remain in the tank.
•Drain and clean the water tank before storage, after seasonal use and whenever the unit is not in daily
use.
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock,
this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
Page
2

Symphony Cooler
Table of Contents
Introduction...............................................................................................................................................................2
Operation Instructions...........................................................................................................................................4
General..................................................................................................................................................................4
Introduction......................................................................................................................................................4
How does your Evaporative Cooler work? ......................................................................... 4
Best Performance locations................................................................................................ 4
Product Specifications........................................................................................................ 6
Installation.................................................................................................................................................................7
Installation Requirements................................................................................................................................7
Unit Casters Installation...................................................................................................................................7
Water Connection...............................................................................................................................................9
Before Startup...................................................................................................................................................10
Operating the unit..............................................................................................................................................6
Maintenance...........................................................................................................................................................12
General................................................................................................................................................................12
Filter Pads......................................................................................................................................................12
Water Tank....................................................................................................................................................12
Water Distributor..........................................................................................................................................12
Motor and Blower Wheel ............................................................................................................................12
Pump Operation ............................................................................................................................................12
Electrical...........................................................................................................................................................13
End of Season................................................................................................................................................13
5 Year Maintenance Planner.....................................................................................................................14
Problem Solving....................................................................................................................................................15
Warranty..................................................................................................................................................................16
Page
3

Symphony Cooler
Operation Instructions
General
Introduction
Your evaporative air conditioner is engineered to meet the rigors of harsh environments. Used and
maintained in accordance with this manual, it will provide you with years of quiet, cool and
environmentally friendly operation. Please take the time to read this manual.
How does your Evaporative Cooler work ?
Warm air is drawn into the evaporative cooler and enter to High Efficiency filters. Water is pumped to
efficiency filters using a submersible pump, warm air is washed through the efficiency filter pads
(absorbing the heat) to provide cool fresh air, blower wheels send the cooled air into room, the warm
stale air within the room is forced out by the cool air throught open doors or windows.
Evaporative cooler produces fresh air eficienctly and inexpensively.
Please Note: This is not an Air conditioner.
Best Performance Location
Indoors
To maximize efficiency, place your Evaporative Cooler in front of an open window, leave another
open window or open door in the opposite to exhaust the warm air. The maximum cooling effect is
felt when a person is near the flow of air produced by the Evaporative Cooler.
Page
4

Symphony Cooler
Operation Instructions
It is essential for successful operation of the evaporative cooler that there be sufficient free air openings in
the room to be cooled –approximately 0.5m² (5.4² feet). Open doors and windows will usually provide this
as per the diagrams below.
Please Note: - It is important for good ventilation that doors or windows are not open on the windward side
of the house. Please note the room furthest away from the cooler needs to have more ventilation than
rooms closest to the cooler.
Outdoors (for outdoor models only)
Use only on GFCI protected outlets/sockets (for USA only). Press the TEST button (then RESET
button) every month to ensure proper operation.
Power cords must be secured to avoid tripping.
The wiring and connections must be protected from water. Electrical plug and Evaporative cooler
connections must be dry at all times. When used outdoors, insert the air cooler electrical plug
into an IP44compliant outdoor electrical outlet.
Set the unit on a solid surface, not recommended to be placed outdoors during heavy rain or
snow.
Page 5

Symphony Cooler
Operation Instructions
Product Specifications
Page
6
MODEL
MOVIL 80
Voltage
120 VAC, 60 Hz, 1 Phase
Amperage
1.8 A
Tank Capacity
21 Gallons (80 Lts)
Net Weight
19 Kg
Unit Dimensions
Assembled
(H X W X D)
45 in X 24 in X 19.68 in
Drain Plug

Symphony Cooler
Installation
Installation Requirements
Tools
•Cordless Screwdriver
•PH2 bits
•Phillips Head Screw Driver
Materials Required (Not supplied)
•Sillcock Valve - for water line connection to faucet (see pg. 9)
Unit Casters Installation
Please follow the instructions for a correct product assembly.
DO NOT connect the power to the cooler until the installation is complete.
•Remove the product from the packaging.
•Locate the Casters kit.
•Insert the Casters Block Raisers into the bottom of the equipment.
•For Assemble, use the 10 screws (8 X 19 mm) included in the casters kit.
Page
7

Symphony Cooler
Installation
Page
8
Introduce the screws into the holes of each
block raisers and fit.
Ensure that the Caster block raisers are fixed
rigidly to the water tank of cooler

Symphony Cooler
Installation
Water Connection
Install a sillcock (not supplied) to the faucet closest to the
cooler.
Using a Spout bucket or plastic hose, add clean water
into the water inlets, to tank. Check the water level
indicator on the Right Side of water tank to see when the
water tank is full.
Your cooler is now ready for startup checklist (see next page).
Page 9

Symphony Cooler
Installation
Before Startup
•Check that another door or window in the room is open to allow air to exhaust to other parts of the
house.
•Ensure that the filters are kept clean.
•Ensure that the water tank is filled with clean water (at least 5 gallons or 20 liters).
•Plug the cooler into a 110 V - 120 V~ 60 Hz single phase grounded appliance socket on the inside
of the house and switch the socket on.
•Press the COOL button to on the water pump.
•Press the Speeds buttons and check the operation of the three speeds motor.
•Leaving the unit in the COOL mode for 15 minutes, you may notice a wet paper smell as the water
circulates around the filter pads. This is normal during the commissioning phase and at the beginning of
each season when the unit is operated after the winter break. It will only last for a short time.
•Drain completely water tank removing drain plug and refill again the water tank to water level
desired.
•Do not add any chemical odor enhancers or liquid detergent of any kind to the tank.
•IMPORTANT. After the first 10 hours of operation in COOL mode, the water must be drained from
the unit water tank to remove any new product residuals. This process must be repeated after a
further 10 hours of COOL mode operation. (See page 12 for removing the Drain Plug). To clean
the tank you must only remove the Drain Plug.
Page
10