SYSFORM S-500 User manual

How to change radius die set on S-500 Corner Cutter
1
Changing blade
(Warning: Sharp knife. Be careful during replacement.)
Switch the machine off.
Remove the clamp.
Remove the left and right side lays.
Loosen the two lower die fixing screws.
Take away the lower die.
Loosen the four fixing plate screws.
Replace a new upper blade back into the original
position and make sure screws fasten tightly.
Switch the machine on then press the inching
button to have the upper blade cut down to the
lowest point.
Put the lower die into the working desk, and
setting two screws.
As shown in the photo, right hand pushes the
lower die to press the upper blade slightly then
fasten two screws.
After replacing the blade, the side lays must be
recalibrated.

How to change radius die set on S-500 Corner Cutter
2
Calibration for side lays
Switch the machine on then press the inching
button to have the upper blade cut down to the
lowest point.
Place the calibration gauge onto the working table.
Push it to let its angle press the upper blade with
no gap.
Push the left and right side lays to close the left
and right edges of the calibration gauge then
fasten their fixing screws.
Sharpening blade and die
Sharpen the upper blade and the lower die, grind
the plane shown at the arrowed place and remove
0.1mm per time.
One sharpening process can sustain for over
10,000 cuts, but still depending on the operation
and the materials.
Lubrication
Refuel lubricant every 30 days for using frequently,
for not often use every 90 days.
Switch the machine off, unplug the power cord.
Remove the cover, lubricate sliding motion
mechanism.
Adjust sliding gap every 90 days for using
frequently, for not often use every 180 days.
Loosen the two screws of lower die, loosen the
two screws of left sliding bar then let the sliding
bar clamp the upper blade carrier slightly then
fasten their screws.
Attention, the blade must be recalibrated after adjustment.