Tactical TPC10 User manual

© 2016 The contents of this
manual are copyright and may
not be reproduced without the
written permission of Tactical
Power Products Pty Ltd.
Installation Manual
AC - DC / DC - DC Convertor -24Vdc Output
TPC10
Tel: [phone] www.tacpower.com.au [e-mail]

No user serviceable parts inside
Do not remove module covers
General
This power convertor is designed for indoor use only.
The TPC10 is a low prole DC - DC / AC - DC Convertor designed to convert either 22-33V AC or 32-48V DC
to a reliable, clean output voltage of 24dc and is rated for 1A continuous output.
Note: Input voltage must not exceed 48V DC - permanent damage may result.
This model features output current limiting and thermal shutdown protection with auto recovery.
Connection
Connect input power to terminals marked “Input” (see diagram overleaf ).
Note that these terminals are not polarity conscious.
Load equipment may be connected to terminals marked “Out”.
Conrm polarity before connecting.
Output voltage is factory set to 24.3Vdc - see note below:
Battery Operation: eective when output is adjusted to 27.6V
Input and output LED’s should be illuminated when operating normally.
There are no fuses or user serviceable components inside the cabinet - return to your supplier for service or
replacement.
Equipment must be installed & serviced
by suitably qualied service personnel
in a restricted access area. There are no
user serviceable parts inside.
Document: TPC10_Rev C.pdf
CAUTION

A B C D E F G
LAYOUT
AOutput Voltage Adjustment (Use an insulated screwdriver to adjust)
BInput OK LED
CInput Terminals: 32-48Vdc - 48Vdc or 22-33Vac nominal
DOutput Terminals: 24Vdc / 1A Max
EBattery Connection - eective when output is adjusted to 27.6V
FOutput OK LED
GMounting Holes
Document: TPC10_Rev C.pdf

TPC 10
Input Voltage 32Vdc - 48Vdc or 22-33Vac nominal
Output Voltage Factory set to 24.3Vdc
Output Current 1A Max.
Output Protection Current Limiting with Auto Recovery, Thermal Shutdown
Operating Temperature 0º C to 45º C
Soft Start 1 - 2 seconds (typical)
EMC Standards CISPR11:2004 - Class B
Dimensions 115 W x 65 D x 40 H mm
Tel: [phone] PO Box 90 Kurrajong NSW 2758 [e-mail]
TPC10
AC-DC / DC-DC Convertor
®
Securing Your Power Needs ®
Now and into the Future . . .
www.tacpower.com.au
Specications : ( In the interests of product improvement, Tactical reserves the right to change specications without notice)