TAD TAD-E1 User manual

2. Remove the sides of the packing container.
Outer carton
3. Remove the tape (six pieces in total) from the inner carton, and remove
the inner carton.
• Afterremovingtheinnerboxandtopprotectionpiece,removetheplasticbagandprotectivesheetcoveringthespeaker.
Inner carton
Inner carton
Top protector
Plastic bag
Bottom protector
Bottom lid
TAD Evolution One
TAD-E1 SPEAKER SYSTEM
Unpacking instructions
This speaker system is extremely heavy (54 kg, or 119 lbs). Be sure
to carry out unpacking and installation with at least two people.
Tryingtohandletoomuchweightcanthrowyouoffbalance,causingyoutofallorotherwise
incurbodilyinjury.
Read before removing your speakers from their packaging.
1. Cut the two packing straps on the outer carton, remove the “handle”-
shaped packing joints (seven places), and cut open the top ap.
• Toremovethepackingjoints,holdtotheleverandpulloutward.
UP
UP
UP
UP UP
UP
UP
UP
UP UP
UP
UP
Straps
Packing joints
X 7
Top flap
Tape
Lever

<SRG1007-A>
4. Take the speaker off the bottom protector.
This speaker system is extremely heavy (54 kg, or 119 lbs). Be careful when
removing it from the bottom protector to prevent possible injury or damage
to the speaker set.
• Inordertoprotecttheflooruponwhichyouaretoplacethespeaker,covertheinstallationareawithathickpieceoffelt
orcarpetwhensettingupthespeakers.
• Useatleasttwopeopletoremovethespeakerfromitsbottomprotector.
• Avoiddraggingthespeakeralongitsbottomside,asdoingsocancausedamagetothespeakers.
TECHNICAL AUDIO DEVICES LABORATORIES, INC.
http://tad-labs.com
© 2011 TECHNICAL AUDIO DEVICES LABORATORIES, INC.
All rights reserved.
5. Remove the bottom protector from the bottom lid, pull off the tape
xing the accessory kit box, and take out the box.
Accessory kit box
nAbout speaker setup
Formoreinformationaboutpropersetup,pleaserefertotheOwner’sManual.
TheOwner’sManualislocatedinsidetheAccessoryKit.