Tanox WeldGuard ADF-206S Use and care manual

ADF-206S - Replacing the Battery
Its easy replacing the battery as you will see in the
following manual:
before you do that please note the following:
1st - it would be easier if you first remove the head band
2nd - while following the next steps please be gentle and
if there are things you're not sure of please ask before
doing, it's always better to be on the safe side...

Replacing the battery
1- pinch the 2 buttons in the direction of the arrows

2- while keeping the pressure, lift the filter case up a bit as
in the following image

3- Release the case from the other side as in the next
image

4- Now the Filter is still inside the filter case but is removed
from the helmet connectors.

5- Release the filter from the left holding pin

6- Release the filter from the right holding pin

7- Now the battery compartment is visible

8- Replace the battery and connect everything back