
Targus Wireless Presenter with Laser Pointer Targus Wireless Presenter with Laser Pointer
11 12
folding line
2 staples here (saddle stitching)
folding line
2 staples here (saddle stitching)
Open size: 9”W x 4.5”H Folded Size: 4.5”W x 4.5”H Material: 80gsm woodfree paper Color: Grayscale Diecut
AUSTRALIAN AND NEW ZEALAND CONSUMERS ONLY
Thank you for your purchase. Targus warrants to the original purchaser that its products are free
from defects in materials and workmanship, during the specied warranty period, and lasts as
long as the original purchaser owns the product. The warranty period is stated on the packaging
or in the documentation provided with this Targus product.
Targus’ Limited Product Warranty excludes damage caused by accident, neglect, abuse, misuse,
improper care, normal wear and tear, ownership transfer, or alteration. The limited warranty also
excludes any product that is not manufactured by Targus (including, without limitation, laptops,
smartphones, devices, tablets, or any other non-Targus item) that is used in connection with the
Targus product.
In the event that the Targus product has a defect in materials or workmanship Targus will, after
receiving a warranty claim and inspecting the product, at its discretion, do one of the following:
repair, replace, or refund with the same or a similar product (or part) of no lesser quality and ship
it to the original purchaser at Targus’ expense. As part of this inspection, proof of purchase will
be required. There is no charge for inspection. To make a warranty claim, please contact Targus
Australia or New Zealand (see details below), or return the product to the place of purchase. The
original purchaser must bear the cost of the delivery to Targus.
Under Australian and/or New Zealand Consumer Laws, in addition to any warranty Targus gives,
our products come with guarantees that cannot be excluded. You are entitled to a replacement or
refund for a major failure and compensation for any other reasonably foreseeable loss or damage.
You are entitled to have the products repaired or replaced if they fail to be of acceptable quality and
the failure does not amount to a major failure.
For any warranty question, contact Targus Australia Pty. Ltd. (i) by mail at Suite 2, Level 8, 5 Rider
Boulevard, Rhodes NSW 2138, by phone AUS 1800 641 645 or NZ 0800 633 222 or by Email:
[email protected]. For additional
information, check out
our website at
targus.com/au/warranty.
Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
RF warning statement
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
FCC Statement
Tested to Comply
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Declaration of Conformity
Hereby, Targus, declares that this device is in compliance with the essential requirements
and other relevant provisions of Directive 2014/53/EU.