Taylor Soft Serve Little Softy User manual

1
= On/Auto Freeze (Far Right Position)
= Off (Middle Position)
= Wash (Far Left Position)
Guide to Using Ice Cream Machine
1. Sanitize before using according to directions
supplied (page 4)
2. Prime the machine according to directions
supplied (page 5)
3. When finished drain the machine according to
directions supplied (page 6)
4. Rinse the machine according to directions
supplied (page 6)
5. Sanitize the machine as you did in step 1 (page
4)
Items Customer needs to have in
order to Use Ice Cream Machine
•Bucket/Container that holds at least 2
gallons
•Soft Serve Mix– Appert’s Food Service is
one supplier 320-251-5450 call for choices
•Container to drain left over ice cream out
of machine into when done.
PLEASE KEEP MACHINE
UPRIGHT EVEN WHILE
TRANSPORTING

2
Operator
Parts Identification
Check List of Items
to be sure are returned with Ice Cream Machine
•Stainless Feed Tube that goes in the hopper (item #3)
•White Plastic Float Mix Level that goes on mix level float
stem in the hopper (item #2)
•Splash shield –located under the freezer door (item #4)
•Black 120 Volt 4-Plug extension cord that comes with
machine
•Please return this instruction sheet
*Customer will be charged replacement cost for any
missing parts *

3

4
How to Sanitize Ice Cream Machine
(This needs to be done before you use the machine & again after you have rinsed the
machine when you are done using it.)
1. Prepare one gallon of sanitizing solution as follows:
In a clean 2 gallon or larger container, mix one pre-measured packet of sanitizing powder with 2
gallons of WARM water.
2. Pour the 2 gallons of sanitizing solution into the mix hopper and allow it to flow into the freezing
cylinder – it will flow in faster if you take the feed tube out – leave it set in the hopper it needs to be
sanitized.
3. Place the toggle switch in the WASH position (move switch to the left). This will cause the cleaning
solution in the freezing cylinder to be agitated.
4. Place an empty pail beneath the door spout and open the draw valve. Draw off all of the cleaning
solution. When the solution stops flowing from the door spout, close the draw valve and place the
toggle switch in the off/middle position. (stop here if you are done using the machine)
If you are just getting started using the machine remove the feed tube from the hopper. (Be sure your
hands are sanitized) Be sure the mix level float is on the mix level float stem. (Figure 21)
5. Move onto Priming Instructions. Prepare your soft serve mix according to manufacturer’s directions.

5

6

7
Trouble Shooting Guide
RESET is on the
left side of the
machine.

8