Techly ICA-LCD H34 User manual

C
9
8
11
10
75x75/100x100 2~8kg
(4.4~17.6lbs)
RATED
32"
MAX
INSTALLATION MANUAL
Extended Reach Wall-Mounted Monitor Arm
LDA34-112
O
Loosen the Screw for
±3° level adjustment
Fully Remove the Screw
for ±180° screen rotation
90°
1
1
N
Keep the monitor arm horizontal
while making spring tension
adjustments. Prior to any arm
movement fully remove the Allen Key.
(Note: DO NOT overtighten screw.)
Use with products heavier than the rated weights indicated may result in instability causing possible injury.
Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.
Safety gear and proper tools must be used. This product should only be installed by professionals.
This product is designed to be installed on solid concrete walls or masonry walls.
Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, contact your place of
purchase for a replacement.
Check that the product is secure and safe to use at regular intervals (at least every three months).
I
M
±180°
±3°/±180°
2
2
3
0°
-90°
±180°
±90°
tilt screen level/rotation
pivot
TO ADJUST LOAD
CAPACITY TURN KNOB
DECREASE INCREASE
Heavier display turns counter-
clockwise.
Lighter display turns clockwise.
ICA-LCD H34

1
W-B W-C W-A H
7
4
3
2
5
6
1
M4x12
M-A
(x4) M5x12
M-B
(x4) D (x4)
M-C
5
W-A (x4) W-B (x4)
A (x1) B (x1)
E (x9)
C (x1)
F (x1) I (x4)G (x1)
J
M5x6 (x20)
K
M6x10 (x4) 6mm
N
(x1)
M
5mm (x1) O (x1)
95mm
(3.7")
ø 12mm
(ø 1/2")
F
G
M-C M-A
M-B 3mm
1
B
1
2
D (x1) H (x4)
L
4mm (x1) W-C (x4)
A
3
D1
K
L
3
2
1
X X
√
2
M-C
M-A/M-B
2
Cable covers should be
installed from the outside of
the arm in toward the wall
bracket (as arrows show).
J
E
EJ
The two screws found on the arm must be positioned through the slot
found on the bottom of the cover.
J
2