Techome TH528-2 User manual

Two/Four Channel Motor Controller
How to Learn a New Remote
1. Open the enclosure
of the Motor Controller.
2. Press the “LRN” button
on the square circuit board.
*A red light will then flash steadily
3. While on CH 1, Press “Open” on the remote.
(or up for the the slimline or “1” on the key fob).
Note. The learning mode on the Receiver times out after 30 seconds
What you need
Procedure
Controller
*Must have power
If the remote has been successfully learned,
the red light will flash rapidly for 0.5 seconds
MOTION AND AUTOMATION
P: [phone] A: 33 Perrin Drive, Underwood, QLD, 4119, Australia
E: [email protected] W: www.techome.com.au

Two/Four Channel Motor Controller
How to Delete remotes
Deleteing All Remotes
1. Press and hold both ‘DEL’ and ‘LRN’ buttons on the receiver.
(’DEL’ button needs to be pressed first).
2. Hold both buttons, the LED light ‘LD2’ will flash for 10 secs.
3. When the receiver has completet deleting the remotes, both
LED lights , ‘LD1’ and ‘LD2’ will stay lit for 2-3 secs.
Deleteing One Remote
1. Press the ‘DEL’ button on the receiver, LED light ‘LD2’
will light up.
2. Press any button on the remote to be deleted and
‘LD2’ will flash fast.
3. Once the remote has been deleted, ‘LD2’ will stop
flashing.
MOTION AND AUTOMATION
P: [phone] A: 33 Perrin Drive, Underwood, QLD, 4119, Australia
E: [email protected] W: www.techome.com.au