Techone SU-27 User manual

Instruction Manual
Su -27
Before use,please read the explanations carefully!
Warning
1.Fuselage side boards 5
2.Wings 3
3.Ailerons 2
4. 2
5.Vertical 2
6.Cabin Cover 1
.Control Horns 4
8.Clevis
9.Velcro 1
.Carbon Fiber Strip
1.Carbon Fiber Rod
12.Steel Wire 0.8*360mm 1
1.Heat-Shrink Tubing mm 1
Elevators
Fins
7
10 1.0*4*500mm 1
4
1 1.3*500mm 2
3 1.5*400
Kit Contents
1. - Electric R\C model is not a toy and is not suitable for the flyer under 14 years.
2.Do not fly near houses or buildings children's play areas road traffic railways airports, overhead
power lines and pylons. Do not fly over people.
3.
4. .
5.Do not fly in the strong winds.
6.Do not try to catch the plane by hand when it is flying.
7.The children who are younger than 14 years old should be assisted by an experienced adult when
the plane is being flown.
Su 27 If misused, it
can cause serious bodily harm and damage to property.
, , ,
Fly only in open areas, preferably AMA (Academy of Model Aeronautics) approved flying sites,
following all instructions included with your radio.
Assemble the kit according to the sequence provided in the instruction manual
Specifications
Fuselage length:826mm(32.5in)
Wingspan:622mm(24.5in)
Flying Weight:280-320g(with battery)
64
30
Servo:6G
: /
: /
Battery:13 -1500
EDF: Φ mm (Motor KV 4500)
ESC: A-40A
Radio 4 more channel
Receiver 4 more channel
11.1V 00 mAh Li-po
2
9
5
8
7
13
12 10 11
4
1
34
6
2
3
1
1
1
TM
1
5
2

Put the side boards into the matched
holes, and f some foam-friendly C/A
fuselage
ixed with .
Holding the aileron tight against
the wing, then fixed with some
clear tape (not included).
Strengthen the carbon strip
inside the slot with some clear
tape(not included).
both sides of the wing
Cut a 45 bevel into the bottom
leading edge of the aileron.
Put the EDF into the prepared hole, and f ixed with hot glue.
Put the carbon strip into the
slot, then fixed with some
foam-friendly C/A.
78 9
12 3
13 14 15
10 11 12
45 6
Sand it if it is need.
Fixed the vertical fins with
.
some
foam-friendly C/A
The elevator
Glue the three parts together.

Assemble your battery into the center of
the fuselage, using a piece of velcro.
Mount your ESC to the fuselage,
using a piece of velcro.
Use a dab of foam-friendly thick
C/A to secure them into place.
Because the size of servos differs,
you may need to cut the servo
mounting hole larger to fit your
particular servos.
Fixed the cabin cover with
some foam-friendly C/A.
Secure one piece of wire to one end
of the carbon fiber rod, using one
piece of heat-shrink material. The
piece of wire should overlap the
carbon fiber rod at least 1" (25mm).
Heat the heat-shrink material with a
heat gun to shrink it into place. PRO
TIP For extra security, apply a few
drops of foam-friendly thin C/A to the
end of the pushrod and allow it to
"wick" into the joint.
Install the control horns. There are
prepared holes on the aileron.
22
23 24
16 17 18
26 27 28
25
19 20
21
21 22 23
Mount your receiver to the fuselage,
using a piece of velcro.

Seek Assistance
If you are new to R/C we suggest you find an experienced pilot to check out your aircraft and help you with
the first few flights. This will help prevent damage to your model and will speed up the learning process
and making your R/C experience all the more enjoyable. You can contact local R/C clubs or your dealer
to obtain the names of experienced R/C pilots who would be willing to help you with your first few flights.
Although this is an it does have some construction features that can be
challenging to the less experienced modeler. If you encounter difficulty in any construction sequence,
please feel free to contact one of our technicians, we stand ready to provide any assistance we can.
Contact us at:
E-Mail: [email protected]
ARF (Almost-Ready-to-Fly) kit,
Copyright 2008 Techonehobby
Http://www.techonehobby.com
TM
C
The Center of Gravity (C/G or Balance Point) is 14.9”
(380mm) from the top of the head, measured at the
center of the wing.
WARNING For test flying and general sport flying, we
suggest you balance the airplane at the C/G
recommended above.
Control throws
Sport Flying
Ailerons: (15.2mm)0.60" Up and Down
Elevator: (21.2mm)0.83" Up and Down
The control throws are measured from the
widest point of the control surfaces
Exponential
Sport Flying
Ailerons: 20%
Elevator: 20%
Made in China
Su-27
-27
is a really fighter which expert in air battle. You can formation flight and chase each
other as well. You will enjoy the super flying speed and the grace and controlled maneuver. It’s
really exciting and interesting. The full sides and ultra clear pattern bring us a brand-new
visual chock. Through the concise and practical structural design, easy and quickly assembly
process. You will enjoy the joy of flying in the shortest time. The package of Su include
exquisite instruction manual and full components.
Exponential softens the response of the control surfaces around neutral stick. This makes the
airplane easier to control while using such large control throws. The Exponential values shown
are given as a percent. Please note that different brands of radio control systems may call for +
or - Expo. Please check your transmitter's owners manual for more info.
"AILVATOR" is applied to this plane.
Introduction
Balance Point
380mm
C/G