Tecnosicurezza T9355/IP User manual

II_T9355/IP_07_eng Page 1 of 2
T9355/IP
: Input/output interface with ethernet port
T9355/IP
includes:
Plastic box
Alarm signals terminals
Ethernet port
Reset button
Keypad/lock connectors
Jumpers NC/NO
For indoor use only.
RS485 PROTOCOL
1. GND
2. RS485 +
3. RS485 -
4. RS485 BUSY
OUTPUTS * Dry contacts
Normally open/closed
Max 30Vdc , 1A
Max 60Vdc , 300mA
Max 125Vac ≂, 500mA
5. OUTPUT 1 (Silent alarm)
6. OUTPUT 1 (Silent alarm)
7. OUTPUT 2 (Penalty)
8. OUTPUT 2 (Penalty)
INPUT * Not isolated
Active low
Short circuit between INPUT and GND to activate the signal.
(do not power the Input)
Max 50Vdc , 20mA
Vil Max= 0,5Vdc Vih Min= 3,0Vdc
9. GND (Remote block)
10. INPUT 1 (Remote block)
11. GND (Remotely managed)
12. INPUT 2 (Rem. managed)
VDC OUTPUT
9Vdc OUT, max 100mA
13.GND
14.9V OUT+
POWER SUPPLY
12Vdc-24Vdc (1A)
15.GND
16.PWR IN +
* Inputs and outputs can be changed by the TechMaster setup software. The
values shown inside the brackets must be considered just as factory values.
TERMINATION RESISTOR 485
ETHERNET
NO/NC
NO/NC
RESET
BUTTON
KEYPAD
& LOCK

II_T9355/IP_07_eng Page 2 of 2
The connection and installation of the interface has to be done by qualified personnel properly trained.
RESET PROCEDURE.
1) Connect the reset-box to any of the keypad/lock connector on the interface.
2) Push and release the reset button. The LED blinks slowly.
3) Wait for 10 seconds. Led turns off.
4) Remove the reset-box.
5) The interface is now reset and it is ready to be installed on the system.
INSTALLATION PROCEDURE.
Before installing the interface, make sure that no ethernet hub is present in the system of interest. The use of
ethernet hub indeed, might cause malfunctions of the interface itself. It is instead allowed using ethernet
switches.
1) Make sure that the interface is in reset mode.
2) Connect the interface to the keypad.
3) Open the lock 1 and keep the bolt open.
4) Enter in the configuration menu.
5) Select ‘Install I/O interface’ submenu.
6) Enter Master code to complete the installation procedure.
7) The interface is now installed and ready to work.
8) When using the interface in 'RS485 mode', make sure the ID is set correctly.