tekkiwear 5880 User manual

CERVICAL MASSAGE INSTRUMENT
5880 / 5830
USER MANUAL
Please read this manual carefully before use.
ATTENTION: There are several versions of this product, the 5880 model that has an internal
rechargeable lithium baery and the 5830 model uses No. 7 (AAA) baeries. be sure to read
the secons corresponding to the model you have purchased. Thank you

5880 MODEL (Charging)
Product name: Low frecuency massage instrument
Power suply: INCORPORATED 3.5V rechargeable baery
Charging: 5V 1A Mobile phone charging adapter
1. Mode display window
2. Socket
3. Switch
4. Silicone sheath
5. Switch
6. Paern
7. Strengthen
8. Weaken
9. Floang stainless Steel sheet
10. Charging port
11. Indicator light
12. Gel patch
13. USB charging cable

5830 MODEL (Baery)
Product name: Low frecuency massage instrument
Power suply: 3Vdc 30ma (2 AAA baeries)
1. Mode display window
2. Socket
3. Switch
4. Silicone sheath
5. Switch
6. Paern
7. Strengthen
8. Weaken
9. Baeries compartment
10. Floang stainless Steel sheet
11. Gel patch

Usage steps for rechargeable massage instrument
1. Dissasemble the outher package and assemble the electrode sheet.
2. Plug the conecng cable into the socket
3. Turn the main control switch to on
4. When the neck is wet, bring the massage instrument
5. Turn on the power switch
6. Select mode by mode
7. First press the buon to exnguish the weak and lower the pressure.
8. Adjust to the appropiate strenght according to the reinforcement

Usage steps for baery massage instrument
1. Dissasemble the outher package and assemble the electrode sheet.
2. Plug the conecng cable into the socket
3. Remove the outer package and install the baeries
4. Turn the main control switch to on
5. When the neck is wet, bring the massage instrument
6. Turn on the power switch
7. Select mode by mode
8. First press the buon to exnguish the weak and lower the pressure.

9. Adjust to the appropiate strenght according to the reinforcement
Operaon Method
1. A Power supply operaon Charging model: Built in 3.7V rechargeable baery.
1. B Baery model: Remove the baery cover and place two No. 7 baeries in the
electromagnec box of the massage instrument according to their polarity.
2. Funcon operaon
1. Pull the power switch of the massage instrument to the "on" posion, wet the cervical spine
and conducve electrode with a wet towel, and then sck the massage instrument ghtly to the
neck. If there are stains on the cervical spine, it must be cleaned before use. When out of use,
turn the switch to the "o" posion
2. Press the "switch" key on the right handle of the massage instrument, the buzzer "beeps", the
working program starts, the indicator 1 ashes, and then press the "strengthen" or "weaken"
key on the le handle once, that is, there are the following sengs, and enter the automac
combinaon 1 massage mode, that is:
A. Automac combinaon mode 1 Massage
B. First gear massage intensity
C. Timing: 15 minutes
3. Use the mode switching key of the "mode" key. Press the "mode" key on the right handle to
select six modes. The default startup seng is mode 1 (automac combinaon 1 mode), and the
mode indicator 1 ashes. The intensity is the rst gear aer each mode conversion.
The six massage modes are:
Mode 1: automac combinaon 1, mode indicator 1 ashes
Mode 2: acupuncture, mode indicator 2 ashes;
Mode 3: massage, mode indicator 3 ashes;
Mode 4: nger pressure, mode indicators 1 and 3 ash at the same me;
Mode 5: kneading, mode indicators 2 and 3 ash at the same me
Mode 6: hammer, and mode indicators 1,2 and 3 ash at the same me.
Automac combinaon mode 1-bit automac cycle Automac combinaon mode is
recommended.
4. Use of "strengthen" key Strength enhancement key: press the "enhancement" key on the le
handle once every me to increase the strength by one gear, with a total of 16 gears. It is

appropriate to massage with self acceptable strength. It is recommended to use a weak gear for
the rst me.
5. Use of "weaken" key Strength weakening key: press the "weakening" key on the le handle
once each me to weaken the strength by one gear, with a total of 16 gears.
The 3D intelligent stainless steel patch works synchronously with the wired massage patch.
Applicaon of gel electrode patch
Plug the meridian line into the meridian hole of the machine, connect the gel electrode patch to
one end, tear the transparent plasc paper on the top of the patch ghtly to the part where the
body needs to massage (two pieces need to be pasted together), and start the work (the
electrode patch needs to work synchronously with the machine).
Aer use, remember to sck the transparent plasc paper to keep the electrode patch clean and
convenient for reuse in the future
Warm reminder: gel electrode patch does not need to wet, electrode patches can probably use
about 10 mes!
TROUBLESHOOTING
If you encounter problems when using the product, please refer to the following ps and
soluons.
- If the product is sll in a fault state or cannot be used, please turn o the power.
- The user should not dismantle or repair the product by himself.
- The product damage caused by the disassembly or repair will invalidate the product warranty,
and the company will not bear any consequences caused by this situaon.
* Unable to start
The baery is low. Please conrm whether the switch buon of the host product has been
pressed
* Cannot charge or no charge lamp display
Please check whether the USB cable and the host and mobile phone power adapter are
connected.
* Normal display but no feeling
Does the electrode pad directly contact the skin? Adjust the posion so that it is close to the
skin.
Are there any items such as hair or clothing, accessories, etc. between the electrode pad and the
skin? Remove or remove the items.
Is the intensity level 1st gear? Adjust to increase the massage intensity.

* Tingling
Is the electrode pad contacng the skin on the neck? You need to adjust the posion to make it
close to the skin.
Is the massage too long? It is recommended to press 15 minutes at a me and twice a day.
Is the massage intensity too strong? Adjust the intensity to a small amount.
Is the skin allergic to electrode pads? Paents with severe allergies need desensizaon
treatment.
Cold climate, dry skin? Use aer moistening your skin with a wet towel.
Is there a wound on the skin surface? Do not put the electrode pads on the wound to massage.
* Smulaon is weak
Does the massager electrode pad say that the neck skin is ght? Adjust the posion so that it is
close to the skin and adjust the appropriate strength.
Is the electrode dirty or oily? Clean the electrode surface.
Is the baery low? If it is low, charge it.
The intensity of the massage posion is too small? Adjust to increase the intensity of the
massage.
Notes on baery life and replacement
Charging model
1. The 3.5V rechargeable baery of the massage instrument can be used for about 1 month each
me it is fully charged
2. This product uses the Android USB interface of 5V 1A for charging
3. The indicator light is on for a long me when charging and o when full
4. The charging me is about 1-2 hours. Do not use it during charging
Baery model
1. The massage instrument uses "AAA LR03" baery, which can be used for about 3 months: (use
once a day for 15 minutes each me)
2. If you do not use this product for a long me, please take out the baery. Otherwise, the
baery may leak and cause the malfuncon of the massage instrument.
3. Do not install the posive and negave poles of the baery incorrectly. See the "+" and "-"
signs clearly. Please dispose of the used baery in accordance with the relevant urban
environmental protecon regulaons.
4. When replacing the baery, please cut o the power supply.

5. (1) installaon and disposal method of waste baery: since the baery contains materials
harmful to the environment, it shall be safely treated as hazardous waste.
(2) How to deal with baery leakage: if the baery is found to be leaking, stop using the product.
Wipe it immediately before use
(3) Before discarding the appliance, the baery must be removed from the appliance.
(4) the baery shall be disposed of safely
CUSTODY
1) Please keep it out of the reach of children.
2) Do not store in direct sunlight, high temperature and humidity.
3) Please keep it in a dry and venlated place.
4) Do not disassemble, repair or modify this product without permission, which may cause
accidents or faults.