TEKTELIC Communications KONA Enterprise User manual

KONA Enterprise Gateway
Quick Start Guide

Note:
Powering up the Gateway
The Kona Enterprise Gateway, supports both internal & (optional) external LoRa antennas, internal GPS, copper
Ethernet backhaul, and optional 3G/4G wireless backhaul with both internal & (optional) external Cellular
antennas. The Kona Enterprise Gateway is powered through Power Over Ethernet (PoE 802.3af).
What’s In The Box:
The following equipment
is provided for installing &
commissioning the KONA
Enterprise Gateway on
TEKTELIC Network Server
•Refer to Antenna Selection Guide for information on antenna use cases
•Refer to User Guide for more information on deployment
•POE Injector, optional External LoRa & Ethernet Antennas sold separately
KONA Enterprise Gateway
Optional LTE Antenna Connection
Optional LoRa Antenna Connection
Covered Panel
Serial Debug-USB
Dual Sim/Micro SD Card - Hybrid Slot
Ethernet Port
Protective Earth Ground

Configuration & Activation
Commission the Gateway using LeapX Application
To use LeapX, you will need a TEKTELIC Account. If you don’t have an account already, please
raise a ticket in our support portal support.tektelic.com and our support team will create an
account for you.
To install LeapX Application on your Smart Device, please search for “TEKTELIC LeapX” on the
Google Play Store or the Apple App Store. Once the app is installed, log in to the app using the
username and password of your TEKTELIC account. Then follow the in-app instructions online
Note:
Once the Gateway shows "Online" you are ready to add
sensors to your network

Gateway Troubleshooting
KONA Enterprise LED States
Note:
If you have questions about this Gateway visit the TEKTELIC Support
Portal at support.tektelic.com for access to our knowledge base.